- 27 -
0900_GB-ISOBUS-Terminal_2441
GB
ISOBUS - TERMINAL
SET-menu
T7
Menu “Setting the lowering time” -> mask (F6)
T8
Menu “Automatic path-offset lifting and lowering function” ->
mask (F7)
T9
Menu “Calibrate angle sensors” -> mask (F8)
a
Front rotary units lowering time
b
Rear rotary units lowering time
Adjustable values: 1- 20 secs.
Menu function:
In this menu the lowering time of the tractor’s hydraulics for the
front and rear rotary unit is adapted.
Testing the lowering time: (depending on tractor)
When all 4 rotors are lowered simultaneously, all cylinders must
be fully extended after the time has expired.
a
Activating the auto function: On/Off
b
Section for path-offset lifting
c
Section for path-offset lowering
Example: (From working position to off-road position lift by 50%, 100% or 150%)
T7
T8
T9
F5
F7
a
b
c
F6
a
b
F8
a
a
T7
T8
T1
T2
T3
Menu function
In this menu the “Lift the preselected rotary units from working
to off-road transport position” and “Lower the preselected rotary
units from off-road transport to working position” buttons are laid
out with and automatic function.
• The gap between lifting/lowering the front rotor and lifting/lowering
the rear rotor is adjusted here.
Tip: This automatic function can only be carried out in the working
position or off-road transport position
At still stand the automatic function is deactivated for safety
reasons!
T1
Reduce working width
T2
Increase working width
T3
Save
a
Voltages
T7...T8
Preselect rotary unit
Menu function
Calibrating angle sensors is necessary through a sensor
exchange.
The function serves to conduct voltages to the end positions.
The rotary units should be in the off-road transport position
• Calibrating procedure for an angle sensor
- Preselect required rotary unit (T7…T8)
- Move to stop (smallest working width) with button (T1)
- Save with button (T3)
- Move to stop (greatest working width) with button (T2)
- Save with button (T3)
- Press ESC button
1
2
2
2
50%
100%
150%
Note!
The automatic function can only be carried out in
the working position or off-road transport position.
At still stand the automatic function is deactivated
for safety reasons!
Note!
With a double click on one of the buttons
all preselected rotors are immediately
activated
