E-53
Projector Options [Setup]
Signal Select
This selects the signal mode of the RGB input, DVI (ANA-
LOG) input, VIDEO input, and S-VIDEO input terminals.
Normally select “Automatic identification”.
If the signal cannot be identified automatically, set to the sig-
nal mode of the output device connected to the projector.
RGB/DVI (Analog)
Set this when the component signal of a DVD player, etc., is
connected to the projector’s RGB terminal or DVI terminal with
a special cable.
Select the mode from the “RGB” or “DVI (ANALOG)” pull-down
list.
Video/S-Video
Set the composite signal format. Set to the signal mode in
your country.
Select the format from the “Video” or “S-Video” pull-down list.
Auto Adjust (RGB only)
Set whether to adjust for offset of the RGB signal display
position and pixels automatically or manually.
Press the ENTER button at “Auto Adjust (RGB only)” to set.
When checked .......... Display position and pixel adjustment is per-
formed automatically.
When not checked .... Display position and pixel adjustment can be
performed manually. See “Position/Clock” on
page E-42.
Note:
Depending on the image, it may not be possible to adjust prop-
erly or some time may be required for the adjustment to be com-
pleted when the signal is switched. In this case adjust manually.
