Recording
06
46
En
Setting the picture quality/recording
time
Before starting a recording, you will usually want to set
the picture quality/recording time. There are four
standard settings available, which allow you to choose a
balance between picture quality and recording time.
It’s also possible to create a fifth, ‘manual’ setting for
picture quality/recording time. Before you can select this,
however, you will need to set the
Manual Recording
option in the Initial Settings menu (see
Manual Recording
on page 110).
•
Press REC MODE repeatedly to select a recording
setting.
•
FINE
– Fine picture quality
•
SP
– Standard play
•
LP
– Long play
•
EP
– Extended play
•
MN
– Manual (available only when manual recording
is on)
The setting is indicated in the front panel display, and
shown on-screen together with the recording time for a
blank recordable disc. If a recordable disc is loaded, the
approximate remaining recording time for that disc is
also shown. (Note that if the On Screen Display setting
(see
On Screen Display
on page 102) is
Off
then this
information is not displayed.)
Basic recording from the TV
Follow the instructions below to record a TV program.
Recording starts immediately and continues until the
disc is full or you stop the recording.
1
Press HDD or DVD to record to the hard disk drive
or a recordable DVD respectively.
• If you’re recording to DVD, load a recordable disc (if
you load a new blank DVD-RW disc, the system takes
a short while to initialize the disc).
2
Use the C/– buttons to select the TV
channel to record.
The front panel display shows the channel number:
• While the DVD/HDD is stopped, you can also use the
number buttons on the remote to select the channel.
(For channel 6, press
6
then
ENTER
; for channel 24,
press
2, 4
then
ENTER
)
VR mode
Video mode
HDD
REC MODE
VR mode
Video mode
HDD
AUDIO
HDD
DVD
ENTER
REC
STOP REC
REC MODE
CHANNEL
2 3 3 0
7
Channel preset
PR
PT-RW_UK.book 46 ページ ２００４年７月２６日 月曜日 午後３時４１分
