Pioneer SC-09TX - Elite AV Network Receiver, Руководство по эксплуатации

Страница: 131 / 160

Additional information
14
131
En
SIRIUS radio messages
i.LINK messages
You may see the following messages displayed in the front LCD display when using the i.LINK interface.
Meaning of messages displayed when the HDMI control function is set to ON
HOME MEDIA GALLERY messages
Symptom Cause Action
Antenna Error
Antenna is not properly connected. Check that the antenna cable is attached securely.
Check Sirius Tuner SIRIUS Connect tuner is not properly connected. Check that the 8 pin mini DIN cable and AC Adapter are
attached securely.
Acquiring Signal The SIRIUS signal is too weak at the current
location. n/a
Subscription Updating
Unit is updating subscription. Wait until the encryption code has been updated.
Updating Channels Unit is updating channels. Wait until the encryption code has been updated.
Invalid Channel Selected channel is not available/does not exist. Select another channel.
Message Explanation
BUS FULL
The i.LINK bus has reached its capacity and cannot transmit any more data.
CANNOT LINK 1 The connection between the receiver and the selected i.LINK-equipped component is unstable. If the
i.LINK cables appear to be connected properly and both the receiver and i.LINK-equipped component are
on, switch both units off, then on again to re-establish the connection between them.
CANNOT LINK 2 The receiver can’t identify the selected i.LINK-equipped component. For example, the receiver may not be
able to identify an i.LINK-equipped personal computer.
LINK CHECK
The receiver is checking the i.LINK network. It does this when components are added to, or removed from
the network. The sound may be interrupted if this happens during playback.
LOOP CONNECT The i.LINK network cannot function because the connected components form a loop. See
The Input Setup
menu
on page 101 for more on this.
NO NAME When an i.LINK-equipped component has no name, this message is displayed instead of the proper
component name.
NO SIGNAL
A component is outputting an i.LINK signal that the receiver cannot reproduce. This receiver can only
reproduce signals from i.LINK-Audio-equipped components. See
About i.LINK
on page 66 for more on this.
PQLS OFF This is displayed on a playback component when PQLS turns off during playback. The sound may be
interrupted momentarily when this happens.
PQLS ON This is displayed on a playback component when PQLS turns on during playback. The sound may be
interrupted momentarily when this happens.
UNKNOWN
When an i.LINK-equipped component name cannot be recognized, this message is displayed instead of
the proper component name.
Message (error number) Problem Remedy
HDMI C ERR 110 to 190
HDMI C ERR 1A0
HDMI C ERR 1B0
HDMI C ERR 1C0
HDMI C ERR 2C0
HDMI cable is not properly connected. • Check the connection.
• There may be a broken wire in the cable.
• This receiver or connected components may be damaged.
No. Message Problem
001 Content playback failed (001). No details are available for the error
100
A communication error occurred (100). No further details are available for the error
101 No response from the server (101). Timeout period reaches due to delayed server response
102
Disconnected from the network (102). Cables are disconnected
103 Invalid response was received from the server (103). Invalid response from the server
300 This format is not supported (300). A file that is not supported is selected
500
Authorization failed (500). Failed to obtain WMDRM authorization
SC_09TX.book Page 131 Monday, November 26, 2007 10:32 PM