Connecting your equipment
03
18
En
10 Multichannel pre-amplifier outputs
Use to connect separate amplifiers for front, center,
surround, surround back and subwoofer channels.
See
Connecting additional amplifiers
on page 71 (see
also
Installing your speaker system
on page 28 for
powered subwoofer connection).
11 MULTI-ZONE audio outputs
Use to connect a second or third amplifier in a separate
room.
See
MULTI-ZONE listening
on page 71.
12 Multichannel analog audio inputs
7.1 channel inputs for connection to a DVD player with
multichannel analog outputs.
See
Connecting the multichannel analog inputs
on
page 67.
13 Stereo analog audio source inputs/(outputs) (x5)
Use for connection to audio sources such as CD players,
tape decks, turntables, etc.
See
Connecting analog audio sources
on page 27.
14 Audio/video source inputs/(outputs) (x7)
Use for connection to audio/visual sources, such as DVD
players/recorders, VCRs, etc. Each set of inputs has jacks
for composite video, S-Video
1
and stereo analog audio.
See
Connecting a DVD/HDD recorder, VCR and other
video sources
on page 24.
15 Composite, S-Video and Component monitor
outputs
Use to connect monitors and TVs.
See
Connecting your TV and DVD player
on page 21.
See
Using the component video jacks
on page 25.
16 MULTI-ZONE video outputs
Use to connect monitors or TVs in a separate room.
See
MULTI-ZONE listening
on page 71.
17 12 V trigger jacks
(total 50 mA max.)
(x4)
Use to switch components in your system on and off
according to the input function of the receiver.
See
Switching components on and off using the 12
volt trigger
on page 75.
18 Component video inputs (x5)
Use the inputs to connect any video source that has
component video output, such as a DVD recorder.
See
Using the component video jacks
on page 25.
19 MULTI-ZONE component video output
Use to connect monitors or TVs in a separate room.
See
MULTI-ZONE listening
on page 71.
20 Control input/output
Use to connect other Pioneer components so that you
can control all your equipment from a single IR remote
sensor.
See
Operating other Pioneer components with this
unit’s sensor
on page 118.
21 RS-232C connector
Use for connection to a PC for graphical output when
using Advanced MCACC or Full Band Phase Control.
See
Connecting a PC for Advanced MCACC output
on
page 77.
22 Remote inputs (MULTI-ZONE and source)
Use for connection to an external remote control sensor
for use in a MULTI-ZONE setup, for example.
See
Connecting an IR receiver
on page 74.
23 Speaker terminals
Use for connection to the main front, center, surround
and surround back speakers.
See
Installing your speaker system
on page 28.
24 AC power inlet
Connect the supplied power cord here.
When making cable connections
• To avoid hum, do not lay connected cables over the
top of the receiver.
• When connecting optical cables, be careful when
inserting the plug not to damage the shutter
protecting the optical socket.
• When storing optical cable, coil loosely. The cable
may be damaged if bent around sharp corners.
Note
1 You must assign the input source to the S-Video input to which you’ve connected your video component (see
The Input Setup menu
on page 101).
SC_09TX.book Page 18 Monday, November 26, 2007 10:32 PM
Содержание SC-09TX - Elite AV Network Receiver
Страница 1: ...uctions REC ...
Страница 160: ......