Panasonic MINAS A5-series, Руководство по эксплуатации

Страница: 284 / 394

Protective
function
Error code No.
Causes Measures
Main Sub
6-12
1. When in Trouble
Protective function (Detail of error code)
*
External
scale status
4 error
protection *1
51 4 Bit 4 of the external scale error code
(ALMC) has been turned to 1.
Check the specifications of the external
scale.
Remove the causes of the error, then clear
the external scale error from the front panel.
And then, shut off the power to reset.
*
External
scale status
5 error
protection *1
5 Bit 5 of the external scale error code
(ALMC) has been turned to 1.
Check the specifications of the external
scale.
*
A-phase
wiring error
protection
55 0 A-phase wiring in the external scale is
defective, e.g. discontinued.
Check the A-phase wiring connection.
*
B-phase
wiring error
protection
1 B-phase wiring in the external scale is
defective, e.g. discontinued.
Check the B-phase wiring connection.
*
Z-phase
wiring error
protection
2 Z-phase wiring in the external scale is
defective, e.g. discontinued.
Check the Z-phase wiring connection.
Forced
alarm input
protection
87 0 Forced alarm input (E-STOP) is applied. Check the wiring of forced alarm input
(E-STOP).
*
Motor
automatic
recognition
error
protection
95 0 to 4 The motor and the driver has not been
matched.
Replace the motor which matches to the
driver.
*
Other error
Other
No.
Control circuit has malfunctioned due to
excess noise or other causes.
Some error has occurred inside of the
driver while triggering self-diagnosis
function of the driver.
• Turn off the power once, then re-enter.
• If error repeats, this might be a failure.
Stop using the products, and replace the
motor and the driver. Return the products to
the dealer or manufacturer.
Note
• When protective function marked with
*
in the protective function table is activated, it can-
not be disabled by the alarm clear input (A-CLR). To return to the normal operation, turn off
power, remove the cause, and then turn on power again.