Panasonic MINAS A5-series, Руководство по эксплуатации

Страница: 109 / 394

2-73
1
Before
Using
the
Products
2
Preparation
3
Connection
4
Setup
5
Adjustment
6
When
in
Trouble
7
Supplement
(SET button)
“ ” increases while
keep pressing (for
approx. 5sec) as the
right fig. shows.
When you change the parameters which
contents become valid after resetting,
will be displayed after finishing
wiring. Turn off the control power once to
reset.
• Keep pressing until the display
changes to when you
execute writing.
* “Start” flashes instantaneously and is
difficult to check visually.
• To write the parameter to EEPROM, press
to change to EXECUTION display.
(Mode switch button)
(Mode switch button)
Writing completes
Writing error
Starts writing.
SELECTION display EEPROM Writing
SELECTION display
Parameter Setup Mode
SELECTION display Auxiliary Function Mode
EXECUTION display
Note
Caution 1. When writing error occurs, make writing again. If the writing error repeats many times,
this might be a failure.
2. Don't turn off the power during EEPROM writing. Incorrect data might be written. If this
happens, set up all of parameters again, and re-write after checking the data.
3. When the error defined by Err.11.0 “Under voltage protection of control power supply”
occurs, is displayed indicating that no writing is made to EEPROM.
2
Preparation
15. How to Use the Front Panel
EEPROM Writing