Panasonic MINAS A5-series, Руководство по эксплуатации

Страница: 229 / 394

4-61
1
Before
Using
the
Products
2
Preparation
3
Connection
4
Setup
5
Adjustment
6
When
in
Trouble
7
Supplement
Trial Run (JOG run) at Torque Control Mode
1) Connect the Connector X4.
2) Enter the power (DC12-24V) to control signal (COM+, COM–)
3) Enter the power to the driver.
4) Confirm the default values of parameters.
5) Set a lower value to Pr3.07 (4th speed of speed setup).
6) Energize the motor by connecting the Servo-ON input (SRV-ON, Connector X4,
Pin-29) and COM– (Pin-41 of Connector X4) to turn to Servo-ON status.
7) Confirm that the motor runs as per the setup of Pr3.07 by applying DC voltage (posi -
tive/negative) between the torque command input (Pin-14 of Connector X4) and GND
(Pin-41 of Connector X4).
8) If you want to change the torque magnitude, direction and velocity limit value against
the command voltage, set up the following parameters.
Pr3.19: Input gain of torque command
Pr3.20: Input rev ersal of torque command
Pr3.21: Speed limit value 1
9) If the motor does not run correctly, refer to P.2-64, "Display of factor for No-motor run -
ning" of Preparation.
• Wiring Diagram
• Parameter
Pr No. Title Setup value
0.01 Control mode setup 2
5.04 Over-travel inhibit input setup 1
3.15 Speed zero-clamp function selection 0
3.17 Selection of torque command 0
3.19 Input gain of torque command
Set up as
required
3.20 Input reversal of torque command
3.21 Speed limit value 1 lower value
• Input signal status
No. Title of signal Monitor display
0 Servo-ON +A
5 Speed zero clamp —
COM+
SRV-ON
SPR/TRQR
GND
COM–
7
29
14
15
41
DC
12V to 24V
In case of one way running
DC
10V
For bi-directional running (Positive/Negative),
provide a bipolar power supply.
2.Trial Run (JOG run)
Trial Run by Connecting the Connector, CN X4
Refer to P.2-28, 29, "Parameter Setup"
(Parameters for Velocity/Torque Con-
trol)