Panasonic KX-TVS75, Руководство по установке

Страница: 109 / 318

5.2 PORT SETTING OPTIONS
CUSTOMIZING THE SYSTEM
109
celebrate the coming of a new and glorious year, however some of our dedicated staff may be
in the office." At this time it would go to the regular recording for the custom service.
Rotary Telephone (1 - 5 - 6 - 6)
Assign only when you are using the Voice Mail Service.
A Must! By default, if an end user calls the Voice Mail Service and doesn't dial anything, the
call will go to the General Delivery Mailbox. This must be changed to send the call to an
operator!
Intercom Paging (1 - 5 - 6 - 7)
Don't forget this screen if you are using the paging feature!!
Set the no-answer time to 30 s, and enter the paging codes for each of the paging groups.
Example: All sales telephones have been placed in extension group 3 in system program
[602]. No hunting type assigned in system program [106]. Assign each salesperson's
mailbox to a different COS in the TVS75/100/200 and assign the paging group to that COS.
(This tells the VPS which paging group to dial). In the Intercom paging section, assign the
number "333" to the paging group assigned to the sales dept.
Fax Management (1 - 5 - 6 - 8)
Assigns up to 2 fax machines that can be extensions from the PBX. If the CNG tone is heard,
the KX-TVS75/100/200 will automatically forward the call to the first fax machine. If the first
fax machine is busy or doesn't answer (is out of paper), the call is forwarded to the second fax
machine. Also allows assigning an extension as the fax manager to be notified on incoming
faxes.
Disconnect Parameter (1 - 5 - 6 - 9)
Determines how many seconds of silence the KX-TVS75/100/200 allows during a caller's
message before disconnecting the call.
RS-232C Settings (1 - 6 - 1)
Allows the system administrator to change the baud, bit, etc.
Port Setting (1 - 6 - 2)
Only to be used if bringing actual CO lines into the VPS. Use the CPC control of the telephone
switch for normal disconnect problems.
Dialing Parameters ( 1 - 6 - 3 - 1)
These parameters are set automatically when Quick Setup is conducted.
Most of the settings will be left alone. The one setting that is changed quite often is the Transfer
Sequence for the operator or the extension. By default it is set at FX on DPT integration and