Panasonic FZ-G1 Series, Инструкция по эксплуатации - Справочное руководство

Страница: 34 / 145

n
<Only for model with Built-in Bridge Battery>
When 5 minutes elapse after removing the battery pack in sleep, the sleep mode will be released.
N O T E
n
<Only for model with Built-in Bridge Battery>
If the built-in bridge battery has enough remaining power, you can replace the battery pack without turning off the computer (Hot swap)
and during sleeping the computer (Warm swap).
1. <Only for model without Built-in Bridge Battery>
Turn off the computer.
Do not use the sleep function.
2. Turn your computer over and remove/insert the battery pack.
Make sure no foreign objects are under the computer.
To remove
Push and slide the latch to the unlocked position, and raise the battery pack.
<Only for model with Built-in Bridge Battery>
Slide the latch (A) to the unlocked position and confirm that the battery indicator (B),
Confirm that the battery indicator on the rear of the computer lights green; this means that the built-in bridge battery has enough remain-
ing power required for a hot swap.
When the battery indicator on the rear of the computer doesn't light; Shutdown, Hibernation and while the AC adaptor is connected to
the computer.
C A U TI O N
n
In the case of a hot swap, finish replacing the battery within a minute. Depending on the built-in bridge battery status, the com-
puter may enter hibernation within one minute. Replace the battery pack as soon as possible.
n
Do not release your hand from the latch (A), while remain connected to the connector part (C).
To insert
- 34 -