Panasonic FZ-G1 Series, Инструкция по эксплуатации - Справочное руководство

Страница: 33 / 145

N O T E
n
Battery goes to sleep if the battery level is about 5%, may be displayed such as “Not exist” or “Not use” is not a malfunction.
Please wait for a while to connect the AC adaptor.
Correcting the Battery Display (Battery Recalibration)
The “Battery Recalibration” function measures and memorizes the battery capacity. To correct the battery display, use this function to fill the battery and
then discharge it completely. Perform the procedure at least once immediately after purchasing the computer. Normally the interval of battery recal-
ibration is 3 months.
The battery display may not be correct when the battery pack deteriorates after a long time use. In this case, perform the procedure again.
1. Connect the AC adaptor.
2. Touch (Start) - (Panasonic PC Settings Utility) - (Support) - (Battery) - [Perform battery recalibration].
3. At the confirmation message, touch [OK].
4. Touch [OK].
The computer restarts, and the “Battery Recalibration Utility” screen appears.
5. Touch [OK].
6. Touch [Yes].
The “Executing Battery Recalibration” screen appears, and start the battery recalibration.
After the battery recalibration is finished, normal charging starts.
N O T E
n
To cancel the battery recalibration, press power switch
n
The temperature range should be 10°C to 30°C {50°F to 86°F}.
n
Frequent recalibration of the battery can degrade the battery. A caution message appears when the battery recalibration is performed
at the shorter interval than approximately a month. In this case, cancel the battery recalibration.
n
If the computer is turned off during the battery recalibration (e.g., due to power failure, or accidental removal of the AC adaptor and bat-
tery pack), the battery recalibration will not be completed.
n
The battery recalibration may take a long time due to the large battery capacity. This is not a malfunction. (An expected approximate
recalibration time is displayed.)
n
<Only for model with Built-in Bridge Battery>
The battery recalibration cannot be performed for the built-in bridge battery.
Replacing the Battery Pack
The battery pack is a consumable item so the replacement will be necessary. If the battery operation time becomes noticeably short and not recovered
even after recalibrating the battery, replace with a new battery.
C A U TI O N
n
The battery pack is not charged when you first purchase it. Be sure to charge it before using for the first time. Charging starts auto-
matically when the AC adaptor is connected to the computer.
n
Use only the specified battery pack with your computer.
n
Make sure no foreign objects are under the computer.
n
In sleep, do not remove/replace the battery pack. Otherwise your data will be lost and the computer may be damaged.
n
If the computer is wet, wipe them off and open the cover. Make sure to dry off the computer, replace/remove the battery pack.
- 33 -