72
Checking distribution data
Operation/Status
Checking distribution data in a list
Details about distribution data (distribution ratios, usage, and charges) are displayed in a list.
For indoor units used in tenanted buildings, it can be difficult to know how much electricity or gas is used
in each area because the same air conditioning system may be used across multiple areas.
By putting the indoor units in each area into “Distribution group”, rates can be calculated based on the
data acquired from the air conditioning units (indoor units and outdoor units) in a “Distribution group”,
and this can help you know how much electricity or gas is used in each area. The rate calculated by this is
called the “Distribution ratio”.
You need to make the following settings before you can check distribution data.
y
Distribution mode settings (P.160)
y
Area group name settings (P.153)
y
Distribution group settings (P.155)
y
Pulse meter settings (P.158)
y
Calendar settings for distribution calculation (P.148)
y
Distribution ratio settings (P.161)
3
Set the period to be displayed.
z
Set the start and end of the period to be displayed.
z
The time at the left is the start of the period and the time at
the right is the end.
(1) Touch
(3-1).
z
The “Calendar” dialogue is displayed showing the current
date.
3-
1
(2) Touch the date (3-2).
z
Use to select the month you want to check. The
current month is displayed if you touch [ThsMth].
z
The settings are registered and the “Calendar” dialogue
closes.
3-
2
Continued on next page
1
Touch [Accumulate/Distrib] in “Oper./
Status”.
1
2
Touch [Distribution data].
z
The “Distribution data” screen is displayed.
2
