16
Troubleshooting the BL-WV10A
154
16.7 Wireless
When 2 BL-WV10A units
are connected, the IP
addresses are the same.
When using Quick Setup for more than one BL-
WV10A, the same IP address will be used for
each.
•
Change the IP addresses to avoid duplication
on the network.
Issue
Causes and Solutions
The image from cameras
for which Quick Setup was
performed is not visible.
When you stand in front of the camera (less than
1 m [39.4 in.] in front of the camera), does the
PRIVACY button turn green?
If not:
•
Change the camera's switch from wired to
wireless.
If it is already set to wireless, re-register the
camera using Quick Setup.
If so:
•
Check the wireless signal strength. Refer to
the wireless communication information on
page 6 and move the camera to a better
position.
Cannot connect to
wireless camera,
connection is unstable.
Other wireless devices are interfering with the
camera's wireless signal.
•
Move the wireless LAN device further away
from the BL-WV10A and camera.
Another wireless LAN device is using the same
channel as the BL-WV10A and wireless camera.
•
Change the wireless channel used by the BL-
WV10A.
Obstacles between the BL-WV10A and the
camera are interfering with the wireless signal.
•
Refer to the wireless communication
information on page 6 and clear the signal
path of any obstacles, or move the BL-WV10A
and camera closer.
•
Connect the camera using a wired connection
if convenient.
Issue
Causes and Solutions
