![background image](http://html1.mh-extra.com/html/panasonic/bl-wv10a/bl-wv10a_operating-instructions-manual_3606778153.webp)
16
Troubleshooting the BL-WV10A
[For assistance, please call: 1-800-272-7033]
153
Camera Quick Setup fails.
Are you following the procedures shown in
"Connecting a camera"?
•
If registration fails, re-initialize the camera,
turn the BL-WV10A off and then on again, and
re-perform Quick Setup.
If you're using the BB-HGW700A, is an Ethernet
cable connecting it to the BL-WV10A?
If you're using the BB-HGW700A, are its camera
settings accurate?
In addition to the router, is there another
Panasonic device serving as an access point?
•
Remove that access point from the network,
and turn the BL-WV10A off and then on again.
[Setting wireless
parameters...] appears.
This message appears when another BL-WV10A
is connected. It indicates that the connected
devices will have the same wireless settings
configured for them.
It's taking a lot of time to
register the cameras.
Network layouts may require a camera re-start, in
which case registration can take up to 3 minutes.
The image from network
cameras is not visible.
During Quick Setup, the BL-WV10A, after
obtaining network data from the router, will seek
out an IP address not currently in use for its own
fixed IP. In addition, there are fixed IP addresses
for cameras on which Quick Setup was
performed. If the same IP address is chosen after
Quick Setup, this will cause network problems.
•
Either change the IP settings for one of the
duplicate IP devices, change the network
settings for the BL-WV10A and the
camera(s), or re-perform Basic Setup after
resetting the default settings for the BL-
WV10A and re-initializing the camera(s).
A signal from a wireless
router is being received,
even though you're not
using one.
This will happen when wireless information is
received from connected devices besides the BB-
HGW700A which support Panasonic's Quick
Setup protocol (including the BL-WV10A itself).
Issue
Causes and Solutions