![background image](http://html1.mh-extra.com/html/panasonic/bl-wv10a/bl-wv10a_operating-instructions-manual_3606778142.webp)
15
Error Messages
142
The timer could not be set
because the recording
start and end time are the
same. Set a different start
or end time.
This error is displayed if the start and end times
during Timer Recording Setup are identical.
•
There must be a difference of at least one
minute between start and end times.
The timer could not be set
because the recording
time overlaps with another
timer. Set a different start
and/or end time.
This error is displayed during Timer Recording
Setup if the day and time are identical to those of
a previously set timer recording.
•
Reset using different specifications for the
recording.
To use the sensor,
first enter the
Administrator
user name and password
on this camera's [User
Info] screen.
This error appears if the ID and password
required for sensor use for remote cameras are
different than those of the administrator.
•
Enter the administrator name and password
in the [User Info] screen.
No camera name entered.
This error appears when either the Image
Confirm or Register button is pressed before
entering a camera name when newly registering
remote cameras.
•
Enter a camera name.
The IP address and port
are not set.
This error appears when either the Image
Confirm or Register button is pressed before
entering a camera address when newly
registering remote cameras.
•
Enter a camera address.
There was a recording
error.
This error appears if for some reason, during
standard recording, the signal from a camera is
lost.
•
Make sure camera monitoring is possible,
then try recording again.
Error Message
Causes and Solutions