6
Setup Menu
100
Note
•
Please be aware that when you make changes to values set during Quick
Setup, you may lose access to the network.
•
If you make a mistake while changing these settings, use the FACTORY
DEFAULT RESET button to restore the BL-WV10A's default settings (see
page 131). Doing so, however, will reset all of your settings to their defaults, and
sever the connections to the cameras. You will need to re-perform Quick Setup
to register the cameras and set desired settings again.
Camera Settings
Change the camera network settings.
Note
•
The administrator name and password must be between 6 and 15
alphanumeric characters in length. The following characters cannot be used:
" < > : &.
•
When you re-register cameras using Quick Setup after changing the
administrator name and password, the user name and password for the camera
Setting
Description
Starting Address
Set the IP address to be used when a camera is
configured using Quick Setup. A maximum of 8
addresses will be created and used, starting
sequentially from this entry. If you run Quick Setup
after connecting a BB-HGW700A, the starting
address will be displayed as [Auto] and cannot be
set manually.
Admin User Name
Set the user name for local cameras for Quick Setup.
This user name is used when connecting to local
cameras.
Admin Password
Set the password for local cameras for Quick Setup.
This password is used when connecting to local
cameras.
