Panasonic AJ-CX4000, Руководство по эксплуатации

Страница: 84 / 223

– 84 –
Chapter 4 Operation — Menu settings
[1920 × 1080PsF] Outputs in 1920 × 1080PsF.
[1280 × 720p] Outputs in 1280 × 720p.
(Factory setting: [1920 × 1080i])
@ @
NOTE
t For the combinations that can be set, refer to “Format that can be output from the <SDI OUT1> terminal” (page 180).
[3G-SDI OUT]
Sets the format of the 3G-SDI signal output from the <SDI OUT1> terminal.
Can be set when the 3G-SDI signal is output.
[LEVEL-A] Selects the LEVEL-A method.
[LEVEL-B] Selects the LEVEL-B DL method.
(Factory setting: [LEVEL-B])
[SDI REC REMOTE]
Sets if the recording operation against the external equipment connected to the <SDI OUT1> terminal (such as recorder) is to be controlled or not.
[ON] Controls the recording operation of the external equipment.
[OFF] Does not control the recording operation of the external equipment.
(Factory setting: [OFF])
@ @
NOTE
t This cannot be set when set to the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL].
[SDI OUT CHAR]
Sets whether to superimpose the character to the output from the <SDI OUT1> terminal.
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [OFF])
[SDI OUT ZEBRA]
Sets whether to superimpose the zebra signal to the output from the <SDI OUT1> terminal.
The setting of the zebra signal is in accordance with the following setting in the [VIDEO OUT/LCD/VF] menu
→ [EI ASSIST].
f [ZEBRA1 DETECT], [ZEBRA2 DETECT], [ZEBRA2]
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [OFF])
[SDI OUT HDR]
Sets the signal to output from the <SDI OUT1> terminal.
[SDR] Outputs in the standard dynamic range.
[HDR] Outputs in the high dynamic range.
(Factory setting: [HDR])
@ @
NOTE
t When the [SCENE FILE] menu → [GAMMA MODE SEL] is set to anything other than [HLG], the camera image is output in the standard dynamic
range.
[MARKER SW]
Marker is displayed in the output from the <SDI OUT1> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[SDI OUT2]
[OUTPUT SW]
Enables/disables the output from the <SDI OUT2> terminal.
[ON] Outputs the video.
[OFF] Does not output the video.
(Factory setting: [ON])
[OUT FORMAT]
Sets the signal to output from the <SDI OUT2> terminal. The item that can be selected varies depending on the [SYSTEM] menu → [FREQUENCY]/
[FILE FORMAT]/[REC FORMAT] setting.