Panasonic AJ-CX4000, Руководство по эксплуатации

Страница: 105 / 223

– 105 –
Chapter 4 Operation — Menu settings
[END VOLT] Sets the voltage to display end remaining capacity when the battery remaining capacity is detected by the voltage level.
The items that can be set are as follows.
f [11.0V] … [14.9V] (0.1 V steps)
(Factory setting: [12.5V])
[NEAR END INFO] Sets the percent value of the near end remaining capacity when the remaining capacity information is acquired from the
battery.
The items that can be set are as follows.
f [4%], [5%], [6%], [7%], [8%], [9%], [10%], [12%], [14%], [16%], [18%], [20%]
(Factory setting: [5%])
[END INFO] Sets the percent value of the end remaining capacity when the remaining capacity information is acquired from the battery.
The items that can be set are as follows.
f [1%] … [10%] (1% steps)
(Factory setting: [1%])
[GENLOCK]
[GENLOCK]
Switches the synchronization signal of the camera.
[INT] Synchronizes to the internal standard signal regardless of the standard signal input to the <GENLOCK IN> terminal.
[GL IN] Synchronizes to the standard signal input to the <GENLOCK IN> terminal.
(Factory setting: [INT])
[H PHASE COARSE]
Performs coarse adjustment to match horizontal synchronization phase when building a system.
The items that can be set are as follows.
f [ − 100]…[100]
(Factory setting: [0])
[H PHASE FINE]
Performs fine adjustment to match horizontal synchronization phase when building a system.
The items that can be set are as follows.
f [ − 100]…[100]
(Factory setting: [0])
[COLOR BARS]
[COLOR BARS TYPE]
Sets the color bar to be used.
[SMPTE] Uses the color bars in SMPTE standard.
[FULL] Uses the full color bars.
(Factory setting: [SMPTE])
@ @
NOTE
t A smear may occur depending on the output resolution.
[TEST TONE]
Sets whether the audio test signal (tone signal with specification level 1 kHz) is output when the video is switched to the color bar.
The standard level varies depending on the setting of the [AUDIO] menu
→ [REC CH SETTINGS] → [HEAD ROOM].
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [ON])
[LED]
[REC TALLY]
Selects the method to display recording status at the camera.
[RED] The red tally lamp illuminates.
[GREEN] The green tally lamp illuminates. (Only in viewfinder)
[CHAR] REC is displayed in characters in the viewfinder and the LCD monitor.
(Factory setting: [RED])
@ @
NOTE
t If set to [GREEN] or [CHAR], the front tally lamp, back tally lamp and rear tally lamp of the viewfinder do not illuminate while this camera is recording.
[ACCESS LED]
Sets whether the card access lamp is to illuminate or not.