- 82 -
- 83 -
ST
AND UNIT
SCREEN C
ONFIG'
GRAPHIC C
ONFIG'
FRAME INS
TALL'
SENSOR C
ONFIG'
OPERA
TION
W
ALL UNIT
OPE-11701
Innovative e-Board of New Conception
e-Board
1
3
4
2
st
nd
ADJUSTER
rd
th
1
3
4
5
6
2
st
rd
nd
GUIDE PIN
th
th
th
ID :
5
ID :
5
ID :
2
ID :
2
ID :
1
ID :
3
ID :
1
ID :
4
ID :
6
ID :
4
5
.
9
. Position the third and fourth MPDP sets closely.
y
Turn the ADJUSTER at the rear side of the upper left MAIN FRAME with the
8
mm Allen Wrench to make the
MPDP sets contact with each other closely.
Turn the ADJUSTER at the rear side of the
upper left MAIN FRAME to position the
MPDP sets contact with each other closely.
Turn the ADJUSTERs in the both sides until
the GUIDE PINs enter into the GUIDE PIN
holes and MPDP sets contact with each
other closely.
5
.
10
. Install the fifth and sixth MPDP sets.
y
Repeat the procedures to install fifth and sixth MPDP sets
y
Be careful not to give any impact to the set to prevent the damage for the MPDP panel.
Turn the ADJUSTER at the rear bottom
side of each MAIN FRAME with an
8
mm
Allen Wrench to higher or lower it.
ADJUSTER
(M
10
*
50
)
WARNING
• Be careful not to give any impact to the set to prevent the damage for
the MPDP panel.
All the connection cables
should be connected prior to
MPDP installation.
Check the MPDP ID numbers
before the installation.
