- 76 -
- 77 -
ST
AND UNIT
SCREEN C
ONFIG'
GRAPHIC C
ONFIG'
FRAME INS
TALL'
SENSOR C
ONFIG'
OPERA
TION
W
ALL UNIT
5
.
3
. Configure MPDP ID and make connections for all the necessary
external devices and power.
y
Set ID, make necessary connections and power before hang the MPDP sets on the wall.
y
There is no space for such work after installation.
y
Refer to
"
2
. Set ID Switch Setting" on page
93
for ID configuration. For further information, refer to the
MPDP user manual.
y
Neatly arrange all the connection cables. If they are stretched out or disorganized, it may cause personal injury
or bad connection.
※
The ID setting in the picture is the exemplary view from the back
ID 3
ID 6
ID 2
ID 5
ID 1
ID 4
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
RS-232C
IN
OUT
DVI-D
OUT
IN
DVI-D
OUT
IN
DVI-D
OUT
IN
DVI-D
OUT
IN
DVI-D
OUT
IN
DVI-D
OUT
IN
RS-
232
C control PC
DVI
!
Note
Prior to the installation, all the connection work should be completed.
OPE-11701
Innovative e-Board of New Conception
e-Board
!
Note
In case of Wall Unit Type, cable connection and MPDP ID configuration
must done prior to MPDP installation.
Check the MPDP ID numbers before the installation.
1
st
GUIDE PIN
ID :
5
All the connection cables
should be connected prior to
MPDP installation.
Check the MPDP ID numbers
before the installation.
5
.
4
. Install the first MPDP set
y
Put the first MPDP set at the lower center position.
y
Insert the PEGs into the PEG holes of the lower center MAIN FRAME and down the set slowly.
y
Be careful not to give any impact to the set to prevent the damage for the MPDP panel.
y
Assemble the GUIDE PINs at the
2
positions on the top surface of MPDP set.
WARNING
• Put down the MPDP set to prevent any damage for the MPDP panel.
Insert the GUIDE PINs into the
holes on the MASTER FRAME.
GUIDE PIN
MPDP
