※
Installation Cautions for e-Board.
Installation Cautions for e-Board
• The installation of e-Board requires extra caution, because the panels of e-Board can be
easily damaged even by minor impact.
• Minimum
20
cm clearance from walls or ceiling must be secured for smooth ventilation
and the product must not be under air tight condition.
If it is installed at the air tight or near air tight places, improper ventilation causes
malfunctions and may shorten the product lifetime by rapid internal temperature rise.
• If it has to be installed at the place of improper ventilation, additional ventilation
openings or fans must be provided to maintain the internal temperature between
0
~
35
℃
.
• For ground of e-Board and application devices, it should be connected as frame ground.
• Considering Max power consumption of e-Board, check the main electricity capacity.
Consideration for easier service
• When you design the exterior design for MPDP system, consider easier disassembly for
possible service occasion in the future.
• The sliding Universal Unit of ORION is recommended for easier service.
• If service people can step into the backside of MPDP system, it can greatly reduce time
and effort for service.
• In case of higher locations, consider the installation location and exterior design for
easier service.
- 10 -
- 11 -
W
ARNING
W
ARNING
• When you install MPDP, make sure there is at least
20
cm clearance for effective
ventilation and do not seal off MPDP sets.
If MPDP sets are installed at the locations of bad ventilation, the inner
temperature can be raised rapidly and it can cause frequent malfunctions and
rapid reduction of the product life.
※
Ventilation space in front of MPDP must be furnished for heat dispersion.If the front space of MPDP
has to be sealed, there must be consideration for the heat dispersion in the rear side of MPDP.
※
Clearance for Ventilation
OPE-11701
Innovative e-Board of New Conception
e-Board
