Orascoptic Spark Series, Инструкция по использованию и уходу

Страница: 7 / 196

Orascoptic
™
Spark
™
Series
INSTRUCTIONS FOR USE AND CARE
Technical Support/Customer Care: 1.800.369.3698 | Outside the U.S. or Canada Call Your Local Distributor 7
Operating Your Spark Series
Operating the Headlight
The Spark series uses capacitive touch controls, making the light simple to operate during clinical procedures.
1. Install a battery pack onto the mounting clip.
2. Touch anywhere on the front or side beveled areas of the battery pack to turn the headlight on
and off.
3. Place your loupe and headlight on your head and adjust to a comfortable working position. Turn the
headlight on and tilt it to the appropriate angle to illuminate your visual field while looking through
the telescopes.
Charging the Battery Pack
Your Spark series comes with two battery packs so that one may be charging while the other is in use. Both
battery packs are partially charged when shipped and should be fully charged prior to use. To charge a
battery, plug the power adapter into an electrical outlet. Plug the USB-to-Micro USB cable into the
power adapter and into the charging port on the back of the battery pack.
• The battery indicator light will blink
SCARLET when the battery pack is nearly depleted and needs
to be charged.
• The battery indicator light will illuminate AMBER while the battery pack is charging.
• The battery indicator light will illuminate GREEN when the battery pack is fully charged.
Installing and Removing the Battery Pack
The battery pack is secured to the mounting clip with locking tabs on each side of the battery pack.
Depress both locking tabs when installing or removing the battery pack. The locking tabs will ‘click’
into place when the battery pack is secure. After installing a battery pack, allow three seconds for it to
activate before attempting to turn the headlight on.
Using the Curing Filter
The curing filter should be used when working with light-cured composites. When applying these
materials, unfiltered light from the headlight can cause premature curing of the composite. The curing
filter is made up of two components; the black bezel ring that is secured to the end of the headlight and the
orange filter that can be flipped up and down as needed during procedures.
• If you don’t require the curing filter for your practice, you can remove it from the headlight. To
remove the curing filter, flip the orange filter to the UP-position and carefully pull the black bezel
ring off the headlight.
Do not pull on the orange curing filter itself .
• To attach the curing filter, flip the orange filter to the UP-position and carefully push the black
bezel ring onto the headlight, making sure the hinge is at the top. Do not push on the orange
curing filter itself .
Troubleshooting
Problem Solution
Headlight does not turn on. Check that the battery pack is charged. Remove and reattach the battery pack, making sure both locking tabs are secure. Attach the other battery pack to determine
if the problem is in the headlight or battery pack.
Battery indicator light is blinking scarlet. Indicates the battery is low. Charge the battery.
Battery indicator light does not illuminate amber while charging. Check that the Micro-USB plug is secured in the charging port on the back of the battery pack. Check that the USB plug is secured in the power adapter. Check that the electrical
outlet is producing power.