![background image](http://html1.mh-extra.com/html/omron/z500-series/z500-series_operation-manual_743394138.webp)
136
SECTION 5
5-8 B
acking
Up
Data to a C
o
mp
uter (Back
up)
Z500
Operation Manual
SECTION 5
Other Functions
5-8 Backing Up Data to a Computer (
Backup
)
Settings for the 4 categories shown below can be saved to or loaded from a computer.
This is a useful function for making the same settings on another device. Also, as a countermeasure
against data corruption and equipment failure, it is recommended that settings are backed up to a
computer.
Example of Operation at the Computer
This section describes data transfer procedures, using Hyper Terminal, a
standard tool for Windows 95/98 and Windows NT4.0/2000. This example is
based on the presumption that an RS-232C cable has been connected to the
COM1 port on the personal computer. Make the necessary adjustments when
the cable is connected to a different port. If using different communications
software, refer to the relevant manual. Data is transferred using XMODEM
(-CRC or -SUM) protocol. XMODEM (-1K) is not supported.
NOTICE
Do not turn OFF the power or input a RESET signal while a message is being displayed in
any save or load operation. Data in memory will be destroyed, and the Z500 may not
operate correctly the next time it is started.
5-8-1 Saving Scene Data to a Computer
The procedure for saving the scene data for
Scn0
to the personal computer is
explained below.
1.
Connect the RS-232C cable to the COM1 port on the personal computer and the
RS-232C port on the Z500.
Selection
Description
Scene
Saves or loads the settings under Set in scene units.
System
Saves or loads the settings (except the settings of
Slant correct
) under
System in scene units.
Sys + scn
Saves or loads both system and scene data (0 to 15) together.
Slant data
Saves or loads the settings of
System/Slant correct.
The following four types of data will be saved or loaded in block.
- For Sensor 0 (Wide) - For Sensor 0 (Zoom)
- For Sensor 1 (Wide) - For Sensor 1 (Zoom)
Computer
Z500
Data
Z500
Содержание Z500 Series
Страница 20: ...18 SECTION 1 1 2 Operational Flow Z500 Operation Manual SECTION 1 Features MEMO ...
Страница 40: ...38 SECTION 2 2 4 Saving Settings and Exiting the Z500 Z500 Operation Manual SECTION 2 Basic Operations MEMO ...
Страница 144: ...142 SECTION 5 5 8 Backing Up Data to a Computer Backup Z500 Operation Manual SECTION 5 Other Functions MEMO ...
Страница 184: ...182 7 3 Analog Output SECTION 7 Z500 Operation Manual SECTION 7 I O Format MEMO ...