Omron Sysmac WS02-CXPC1-EV3, Руководство по эксплуатации

Страница: 61 / 390

PART 1: CX-Programmer
OMRON CHAPTER 3 – Project Reference
CX-Programmer _Page 35
Name
When this option is selected it is possible to set the number of lines to be shown for a symbol name, and whether
they are shown above or below the element (i.e. above or below a contact or coil).
Address
The If name empty option will only show the address of an operand if there is no symbol attached to the
address, or if the symbol is unnamed. The After name option shows the address after the name, separated by a
comma. The Above and Below options show the address on a separate line, above or below the element
respectively.
Comment
When this option is selected it is possible to set the number of lines to be shown for a comment, and whether
they are shown above or below the element (i.e. above or below a contact or coil).
Instructions
A range of options are given to determine the information and format of data within instructions.
The Show data with option allows a choice of where monitoring data will be shown within the operand box of
an instruction. It can be shown below the name, address or comment of the symbol. It can also share the line of
the name, address or comment, so that the monitoring data is shown before the information on the same line.
This allows the size of the instruction box to be minimised.
Show on right for output instructions
A range of information can be shown on the right of output instructions (i.e. coils and right-hand instructions
such as 'MOV').
The Symbol Comment of the symbol used within the operand can be shown. If this option is set, the comment
is no longer shown inside an output instruction or coil cell.
The Attached Comment (comment property of the instruction element on the diagram) can be shown.
The Instruction Description (shorthand description of the instruction, the same as that shown in the Instruction
dialogue) can be shown.
The Operand Description (shorthand description of the operand purpose, the same as that shown in the
Instruction dialogue) can be shown.
Note that it may not be possible to fit all of the requested information on the right of the instruction - the height
of a cell is not determined by these choices. The 'Attached comment' is always shown first (i.e. highest priority),
followed by the 'Symbol Comment' and then the descriptions.