Omron Sysmac WS02-CXPC1-EV3, Руководство по эксплуатации

Страница: 58 / 390

PART 1: CX-Programmer
CHAPTER 3 – Project Reference OMRON
CX-Programmer _Page 32
4. Setting the Show grid by default will place a dot pattern around each cell on the ladder
diagram. This pattern can aid element placement, but may be removed for a clearer
display.
5. If the Show rung annotation lists is set then the list of comments which are within the
rung (both attached comments associated with particular elements within the rung, and
unattached comments) will be listed below the rung comment. Note that this option can
be quickly changed via the
View Rung Annotations button on the toolbar.
6. If the Monitor in hex is set then the online monitoring format of values within PLC
addresses will always be shown in hexadecimal. This may be toggled from the toolbar.
7. Setting the Allow Address Referencing without Window option allows use of the Go to
Input , Go to Output , Go to Next Address Reference and Go to Previous Jump Point
commands when the address reference tool is not on show. If this option is not set, then
the tool must be visible to use these commands. Note that when address referencing is
active, a small delay may be experienced when moving around a diagram, depending
upon the size of the PLC program/s.
8. Setting the Show actual I/O bit in XY will change the prefix of addresses ‘I:’ and ‘Q:’,
which are mapped to either an input unit or an output unit, to ‘X:’ and ‘Y:’.
9. Setting Check duplicated output and TIM/CNT No. executes a check for an output and
timer/counter, whether the address is already used in the program or not. The result may
be displayed on the Output window.
Note that addresses used as SET and RESET instructions will not be checked, since these
are frequently used in pair.
10. Setting Synchronise ladder and mnemonic cursors allows the position of the cursor in the
mnemonic view to move to the same step number as the cursor in the ladder view moves.
11. View to show when split – enables two different views to be shown within the editing
window. It is possible to choose to see a part of the editing in mnemonic mode and the
other in ladder, or to see the local symbol table of the program in one view.
12. Setting the Show right bus-bar will show the right bus-bar with the ladder rungs justified
to fill the space between the left and right bus-bars. The output instructions will appear
aligned along the right bus-bar, as long as the rung can be drawn within the number of
cells to the right bus-bar. If the
Expands to Widest Rung option is chosen, then the right
bus-bar position for a section is automatically set to the widest rung in the program
section. Note that this may result in slower performance on a large section when editing
or adding rungs, since if a rung is expanded beyond the current width, the section will be
reformatted.
If no right bus-bar is shown, the rungs are justified to the left, minimising space.
13. Setting Show in simple dialog mode allows Contact, Coil or Instruction dialogues to open
in small sizes. The Show with comment dialog option allows dialogues to display for
entering comments in simple dialogue mode.
14. Select the OK pushbutton to apply the settings and close the dialogue. Select the Apply
pushbutton to change the settings but remain in the dialogue. Select the Cancel
pushbutton to abort the operation.
PLCs
The PLC tab provides a default PLC and CPU which appears when adding a new PLC to a project.
Use the following procedure to change PLC preferences.
1, 2, 3… 1. Select the PLC tab within the Options dialogue.
2. Set the Confirm all operations affecting the PLC setting to receive a confirmation
message for computer to PLC communications.
3. Select the default PLC from the PLC Type field. When set CX-Programmer will show a
confirmation dialogue when an operation being carried out may affect the running of a
PLC.