Omron Sysmac WS02-CXPC1-EV3, Руководство по эксплуатации

Страница: 164 / 390

PART 2: CX-Server PLC Tools
CHAPTER 3 – IO Table Component OMRON
CX-Server PLC Tools_Page 22
7. Select Transfer from PLC from the Options menu to write the changes back to the table.
The IP Router Table establishes communications between different networks by maintaining the IP address for
each interface and is created by clicking on the
Insert pushbutton above the IP Router table dialogue.
Procedures are the same as for the IP Address Table described above.
Syslink Unit and Controller Link Specific Settings
A Syslink unit Software Switches dialogue includes a General tab and Data Link tab described previously.
The Error Information tab provides read-only information regarding the errors that the PLC can detect and raise
an error flag.
The Network Status tab provides network status information. It also activates the PLC to perform internode
tests. Select the Start option to set the PLC to check for errors and report them. Select the Stop option to stop
the PLC from detecting errors. The Network Node List field lists the network nodes and whether they are
participating in the network operations.
Sysmac-Bus2 Unit Specific Settings
A Sysmac-Bus2 unit Software Switches dialogue includes a General tab described previously.
The Slave tab provides specific status information to the Sysmac-Bus2 unit. There are various types of slave
that may be connected to a Remote IO Master unit. These slaves include IO Terminals, Programmable
Displays and Remote IO Slave units.
To view the slaves connected for a group, select the Group required from the field at the top of the Slaves tab.
The remainder of the Slaves tab displays the Node and Status for each category.
If the hierarchy of the IO Table has been expanded, the three groups can be populated with other units:
♦
Group 1. 16-point and 32-point IO units.
♦
Group 2. 16-point, 32-point, 64-point and 128-point IO units and 256-point dummy.
♦
Group 3. 58M Remote Terminal, 54MH Remote Terminal and 122M Remote Terminal.
Serial Communications Unit Specific Settings
Serial Communications unit specific software switches settings can only be set for CS1-series PLCs.
A Serial Communications unit Software Switches dialogue includes a General tab described previously.
The Port 1 tab and Port 2 tab are identical. Settings can be specified for the Format field, Mode field and
Hardware field.
IO Table Management
Changes made to an IO Table can be done by simply editing particular fields in the table. Basic information
can be changed by displaying the configuration, selecting the rack or unit that needs to be changed and editing or
selecting the new IO address or configuration information.
All slot allocations in the IO Table can be cleared. Select Clear from the Options menu.
An IO Table unit in the PLC’s Registered IO Table in the PLC can be deleted. Use the following procedure to
delete an IO Table Unit.
1, 2, 3… 1. Highlight the rack/unit in the IO Table to be deleted.
2. Click the right-mouse button and select Delete .
The CX-Server IO Table component can be examined to determine if it has a valid configuration. To check an
IO Table, select the
Check option from the Options menu. A message is displayed indicating whether the
operation was successful or not.
The CX-Server IO Table component can compare the local IO Table on the PC with the CX-Server project
settings and displays any differences or errors. Select the
Compare with Project option from the Options menu.