Omron Sysmac WS02-CXPC1-EV3, Руководство по эксплуатации

Страница: 200 / 390

PART 2: CX-Server PLC Tools
CHAPTER 8 – CX-Net Network Configuration Tool OMRON
CX-Server PLC Tools_Page 58
3.
Select the Show Unit Status button from the toolbar or select Unit Status from the PLC
menu.
4.
Select the Clear Log pushbutton to delete the entries in the error log.
5. Select the Close pushbutton to remove the dialogue.
Note:
Unit status and error log data for Communications Units (e.g., Controller Link Units
and SYSMAC LINK Units) can be written to files in CSV format. Click the Save
button in the PLC Unit Status dialog box and the Save As dialog box will appear.
Select the CSV format and the folder in which to save, input the file name, and click
the Save button. The status of the Communications Unit and the error log data will be
saved in a CSV file.
This function allows network errors to be analysed from CSV files.
Note: With a C-series PLCs, the error log for a Communications Unit (e.g., Controller
Link Unit or SYSMAC LINK Unit) can be saved using PLC | Unit Status/Error Log.
Testing the Network Connection
Once network connections have been created, the network should be tested to ensure that all nodes are
responding properly. The following tests are available:
♦
Internode Echo-Back Test . This test checks the condition of a number of specific network and node
address and whether communications can be established;
♦
Broadcast Nodes Test . This test examines all nodes on the network and is available for Ethernet,
Controller Link and SYSMAC LINK only. This test may take some time for an Ethernet network which is
not subject to the same size restrictions as Controller Link and SYSMAC LINK. The results show all
nodes found and the PLC type if possible;
♦
Ping Node Test . Allows echo testing of a specific TCP IP address.
Select the required test from the associated button in the toolbar, either the Echo Back Test
button, the Broadcast Test button or the Ping Test button.
Communications Unit Setup
The Configure Communications Unit button from the toolbar is used for SYSMAC LINK,
SYSMAC NET and Controller Link setup options on SIOU units for C-series PLCs. These
options only describe settings that cannot be accessed via the IO Table component.
For CS1-series PLCs and CV-series PLCs, the setup allows SYSMAC NET, SYSMAC LINK and Controller
Link setup. This information is defined via the IO Table component; refer to
Chapter 3 - IO Table Component
for further information.
Select a unit type from the Unit Type field. If provided, select the Setup pushbutton to further configure
communications setup. Select the Close pushbutton to close the dialogue.
SYSMAC LINK Settings
The SYSMAC LINK menu only appears when the end connection is the SYSMAC LINK network. It allows
settings specific to a SYSMAC LINK network to be made.
Network Status
The SYSMAC LINK Network Status dialogue shows the nodes present on the network. It also indicates the
controlling server node. Use the following procedure to setup SYSMAC LINK Network Status settings.
1, 2, 3… 1. Select the Network Status option from the SYSMAC LINK menu.
2. Select the Close pushbutton to remove the dialogue.
Network Settings
The Network Settings dialogue allows parameter settings for a SYSMAC LINK network to be defined; this
includes the maximum number of nodes on a network, the maximum number of polling units per
communications cycle, and the maximum number of frames per communications cycle.