![background image](http://html1.mh-extra.com/html/omron/ns15-v2-series/ns15-v2-series_setup-manual_743134242.webp)
6-10 Starting Operations
6-68
6-10 Starting Operations
The host and PT connected to it start operating after the project data has finished being
transferred and the System Menu settings (communications conditions with the host, etc.)
have been completed.
Precautions
for Safe Use
Start actual operation only after sufficiently checking the operation of the screen
data and host programming.
z
Switching to RUN Mode and Starting Up
Pressing the Exit
Button at the top right of the screen in the System Menu will display the
screen that was displayed before moving to the System Menu, change the status to RUN
mode, and start running the PT. The pop-up screens that were open before switching to the
System Menu, however, will not be displayed.
Reference
The error message indicating a project read error will be displayed if the System Menu is
closed while screen data is being initialized. Always transfer the screen data from the
CX-Designer or Memory Card after initializing screen data.
z
Checking Communications with the Host
Execute the host program and check that the following operations are normal.
•
Check that the PT screens will switch according to the host program.
If the screen displays cannot be switched normally, check whether the PT and host are
connected properly, and whether the hardware settings are correct. For details, refer to
Section 4 Connecting the Host to Serial Port
or
Section 5 Connecting to Host via Ethernet
or Controller Link
.
•
Use the Support Software (CX-Programmer, etc.) to display the details on words and bits
to check that the results of PT button operations and numerical/character string input op-
erations have been properly transmitted to the host.
•
If the operation results are not transmitted to the host properly, check the object settings.
Refer to the object descriptions in the
PT Programming Manual
for details on object set-
tings.
Содержание NS15-V2 Series
