![background image](http://html1.mh-extra.com/html/omron/ns15-v2-series/ns15-v2-series_setup-manual_743134015.webp)
13
26. To ensure safety when using numeral input functions, set the upper and lower limits for the
input value.
27. Before initializing screen data, confirm that existing data is backed up at the CX-Designer.
28. When changing the password with the system menu, do not reset or turn OFF the power
supply until writing is finished.
29. When using the device monitor, confirm the safety of the system before performing the
following operations.
•
Changing monitor data
•
Changing operation modes
•
Forced setting or resetting
•
Changing present values or set values
30. Dispose of any battery that has been dropped on the floor or otherwise subjected to
excessive shock.
31. Do not connect an USB connector to any device that is not applicable.
32. Before connecting an USB connector to a device, make sure that the device is free of
damage.
33. Commercially available USB hubs and the recommended USB hub do not necessarily
have the same general specifications as the PT, and may not function properly if used in
environments subject to static electricity or other forms of noise. When using a USB hub,
take sufficient measures to prevent static electricity and other forms of noise, or do not
install the PT in an environment subject to such noise.
34. Do not perform the following operations while downloading or uploading screen data or
system program. Doing so may corrupt the screen data or system program.
•
Turning OFF the power supply to the PT
•
Pressing the PT’s reset switch
35. When mounting the Battery, be sure to use the correct Battery and mount it correctly.
36. Do not disassemble or short-circuit the battery.
37. Dispose of the Units and batteries according to local ordinances as they apply.
38. Never use volatile solvents, such as benzene or thinners, or chemical dusters to clean the
PT.
39. The backlight in the NS-series PT contains mercury. Do not dispose of the PT together
with waste to be processed at disposal plants. Dispose of the PT according to all local
laws, regulations, and ordinances.
40. The backlight in the PT cannot be replaced by the user. Contact your OMRON
representative for backlight replacement.
41.
Periodically check the installation conditions in applications where the PT is subject to
contact with oil or water.
42.
The NS15-TX01
@
-V2 uses an analog touch panel.
Deterioration over time can cause the
touch points to move. If the touch points move too far, calibrate the touch panel.
43. Never connect more than two crimp terminals to one terminal.
44. Water and oil resistance will be lost if the front sheet is torn or is peeling off. Do not use
the PT if the front sheet is torn or is peeling off.
45. The Rubber Packing will deteriorate, shrink, expand, or harden depending on the
operating environment. Inspect and replace the Rubber Packing periodically.
Содержание NS15-V2 Series
