15
How to mount the Option Board on the Inverter
Section 2-3
Step 2
Cut out the 2 plastic break-outs
from the Front Cover.
Make sure no sharp edges
remain.
Step 3
Remount the Front Cover and
tighten the screws
Step 4
Purpose: mount the Inverter
Connector (no.1) of the Option Board
onto the interface connector (no.5) of
the RX Inverter.
How to do:
First align the small hole of the
Inverter connector (no.2) with the
guide-post (no.4) in the Inverter.
Then align the larger hole on the
Inverter connector (no.3) with the
threaded hole (no.6) in the Inverter.
Push the Inverter connector into
place.
I111E-EN-02+3G3AX-MX2-RX-PRT+OperManual.book Seite 15 Donnerstag, 8. September 2011 11:53 11
Содержание 3G3AX-MX2-PRT-E
