Omron 3G3AX-MX2-PRT-E, Руководство пользователя

Страница: 43 / 116

29
Section
SECTION 4
Operations and Monitoring
This section provides some common usage examples to help you get started.
Unless otherwise specified, all usage examples make use of the PROFIdrive
device profile and associated modules (Refer to section
3-1 Configuring the
Option Board
,
Step 1
). Prepare the Inverter and Option Board before starting
with the usage examples:
Step 1 Initialize the Inverter mode to Induction Motor, Constant Torque:
Set b171 = 1 and then b180 = 1, set b049 = 0.
Refer to MX2 User’s manual (Cat. No. I570) section 3-6-24.
Set b084 = 2 and then b180 = 1, set b049 = 0.
Refer to RX User’s manual (Cat. No. I560) section 4-2 Parameter Initializa-
tion).
Step 2 Configure the Option Board and Network as explained in sections
3-1 Config-
uring the Option Board
and
3-2 Configuring the Network
, but limit the follow-
ing choices:
• When selecting the device profile when configuring the Option Board
(
Step 1
of section
3-1 Configuring the Option Board
), select the PROFId-
rive device profile by setting P182 to 0.
• When configuring the process area content (of section
3-1 Configuring
the Option Board
), set all parameters (P160 - P179 to 0).
• When choosing the module while configuring the network (
Step 6
of sec-
tion
3-2 Configuring the Network
), select either the PPO Type 2 or PPO
Type 5 module.
If you configured everything correctly, your output and input process areas
should contain the following data:
Table 14 Output Process Area
!WARNING
A revision AAAA Inverter allows the motor to run immediately if a trip condition
is reset, and at the same time, Run (STW) is set. For safe operation clear Run
(STW) when you detect a rising-edge on Flt (ZSW). Refer to section 1-1-2
Inverter Support to determine the Inverter revision.
dec
hex
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
- - - - - Ovr JR JF Rst - - Run En - - -
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
En
Run Run operation
Run enable
JF Jog run forward
Rst Fault reset
PKE
IND Task ID and parameter number
Parameter index Ovr Control override
JR Jog run reverse
HSW
PWE
STW Parameter value
Control word
Frequency reference
Value
-
+4
- - -
+9
STW HSW
+8
IND Register
Word offset +1 +0
PKE
0 0 0
PWE
0
+6 +7 +2 +3 +5
0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0
Value
0
00000000
Name
0
Bit
0
0000
I111E-EN-02+3G3AX-MX2-RX-PRT+OperManual.book Seite 29 Donnerstag, 8. September 2011 11:53 11