Olivetti PF-P09, Руководство по обслуживанию

Страница: 372 / 457

Field Service Ver. 1.1 May 2011 20. FAX ERROR
329
TROUBLESHOOTING
(26) Error code: 00B5
(27) Error code: 00B6
(28) Error code: 00B7
(29) Error code: 00B8
(30) Error code: 00B9
(31) Error code: 00BC
Definition Can not detect phase 3 signal after phase 2 within 25 seconds.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Boost the machine TX level. <*1>
3. Change the machine TX speed to V.17, then resend again.
4. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition Can not detect phase 4 signal within 25 seconds after CM/JM exchange.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Boost the machine TX level. <*1>
3. Change the machine TX speed to V.17, then resend again.
4. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition Can not detect phase 5 signal after phase 4 within 30 seconds.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Boost the machine TX level. <*1>
3. Change the machine TX speed to V.17, then resend again.
4. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition Remote side disconnect after our side sending DCS signal in V.34.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Boost the machine TX level. <*1>
3. Change the machine TX speed to V.17, then resend again.
4. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition Receive T.30 signal other than DIS, DCS, CFR after sending DCS signal in V.34.
Solution 1. Change the machine TX speed to V.17, then resend again.
2. Print out the protocol report, and search for technical support.
Definition Modem can not ready within 10 seconds after entering primary channel in V.34.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Boost the machine TX level. <*1>
3. Change the machine TX speed to V.17, then resend again.
4. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
d-Color MF2400