Olivetti d-Copia 600, Руководство по обслуживанию

Страница: 65 / 454

1-3-29
Install the optional hard disk.
1. Remove the two pins, and then remove the
HDD cover.
2. Slide in the hard disk along the rails, and
then secure it with the two pins.
After installation, the hard disk must be for-
matted. Turn the main power switch on, go
to the printer screen and select the [Printer
Menu] followed by [Hard Disk] and then
[Format].
Figure 1-3-59
Installing the optional serial interface
1. Remove the five screws and the two pins, remove the printer system, and remove the cover.
2. Plug the 10-pin connector of the serial interface into YC8 of the printer board, and pass the
power cord through cutout in the board.
3. Secure the serial interface to the printer board using the two pins.
4. Slide in the printer board along the rails, and then secure it with the five screws.
Take care that the power cord does not come into contact the frame edge.
Figure 1-3-60
Installing the optional memory DIMM
1. Remove the printer board, and insert the
optional memory DIMM firmly into either of
the memory slots.
2. Push the DIMM firmly into the slot so that
the two hooks (one hook at each end of the
slot) snap closed.
3. The board provides two DIMM slots, and
can accept up to two optional DIMMs. If
installing a single DIMM, you can use either
slot.
Figure 1-3-61
HDD
Pins Pins
HDD
cover
Hard disk
Screws
Screws
Screws
Screws
Pins
Pins
Cover
10-pin
connector
Serial
interface
Serial interface
Printer
board
Printer board
Printer board
Memory slot Hook
Hook
Memory DIMM
Y104350-7 Sevice Manual