Olivetti d-Copia 600, Руководство по обслуживанию

Страница: 357 / 454

2-1-20
2-1-7 Fuser section
The fuser section consists of the parts shown in the figure.
When the paper reaches the fuser section after the transfer process, it passes through the gap between the press roller
and heat roller, which is heated by fuser heaters M, S and L (FH-M, FH-S and FH-L).
where pressure is applied by the pressure springs so that toner on the paper is melted and fused onto the paper
When the fuser process is completed, the paper is separated from the heat roller and press roller by their separation claws
and is ejected out of the copier by the rotation of the fuser eject pulley and roller.
The cleaning felt in contact with the heat roller cleans the surface of the heat roller.
The lower cleaning roller in contact with the press roller cleans the surface of the press roller.
Figure 2-1-23 Fuser section
(1) Fuser base
(2) Press roller
(3) Fuser A front guide
(4) Fuser eject mount guide
(5) Lower cleaning roller
(6) Fuser eject lower guide
(7) Press roller separation claw
(8) Heat roller
(9) Fuser upper guide
(10) Fuser stay
(11) Fuser thermostat (FTS)
(12) Fuser thermistor M (FTH-M)
(13) Fuser thermistor S (FTH-S)
(14) Fuser heater L (FH-L)
(15) Fuser heater M (FH-M)
(16) Fuser heater S (FH-S)
(17) Fuser cleaning support plate
(18) Web pressure roller
(19) Cleaning felt
(20) Fuser cleaning cover
(21) Upper fuser cover
(22) Fuser eject upper plate
(23) Fuser eject upper guide
(24) Heat roller separation claw
Service Manual Y104350-7