Olivetti d-Copia 600, Руководство по обслуживанию

Страница: 39 / 454

1-3-3
When taking out the machine, a space for
machine rear requires approximately 2 m.
1. Remove the hinge joints, and then remove
the upper case, the upper spacer, the upper
left spacer, the upper right spacer, the outer
case and the supports.
2. Cut four tapes of the skid each corner.
3. Cut each tape which locks the slope and the
spacer.
4. Rotate slopes as shown in the figure and
make them for machine sliding.
* Finally, check that there is no level differ-
ence in slopes (circle section of figure 1-3-
2).
Figure 1-3-2
Taking out the machine.
Slopes
Y104350-7 Sevice Manual