Troubleshooting and routine maintenance
131
C
Document Jam
The document was not inserted
or fed properly, or the document
scanned from the ADF was too
long.
See
Document jams
on page 136 or
Using the
ADF (automatic document feeder)
on page 18.
DR Mode in Use
The machine is set to Distinctive
Ring mode. You cannot change
the Receive Mode from Manual to
another mode.
Set Distinctive Ring to
Off
. (See
Turning off
distinctive ring
on page 50.)
Drum Error
The corona wires on the drum
unit needs to be cleaned.
Clean the four corona wires on the drum unit.
(See
Cleaning the corona wires
on page 154.)
EL Error
The machine has a mechanical
problem.
Open the front cover and close it again.
Fuser Error
The temperature of fuser unit
does not rise at a specified
temperature within specified time.
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine for
15 minutes with the power on. The machine can
be turned off for up to 4 days without losing faxes
stored in the memory. (See
Checking if the
machine has faxes in its memory
on page 135.)
The fuser unit is too hot.
Init Unable XX
The machine has a mechanical
problem.
Turn off the machine’s power switch and then
turn it on again. If the error message continues
leave the machine for several minutes and then
try to print, copy or scan again. The machine can
be turned off for up to 4 days without losing faxes
stored in the memory. (See
Checking if the
machine has faxes in its memory
on page 135.)
Jam Duplex
The paper is jammed in the
duplex tray.
(See
Paper jams
on page 137.)
Jam Rear
The paper is jammed in the back
of the machine.
(See
Paper jams
on page 137.)
Jam Inside
The paper is jammed inside the
machine.
(See
Paper jams
on page 137.)
Jam MP Tray
The paper is jammed in the MP
tray of the machine.
(See
Paper jams
on page 137.)
Jam Tray 1
Jam Tray 2
The paper is jammed in the paper
tray of the machine.
(See
Paper jams
on page 137.)
Low Temperature
The temperature of the machine
is too cold.
Increase room temperature to allow the machine
to operate.
No Belt Unit
The belt unit is not installed.
Install the belt unit. (See
Replacing the belt
unit
on page 178.)
No Drum Unit
The drum unit is not installed.
Install the drum unit. (See
Replacing the drum
unit
on page 172.)
No Paper
The machine is out of paper or
paper is not properly loaded in the
paper tray.
Do one of the following:
Refill the paper in the paper tray or MP tray.
Remove the paper and load it again.
Error Message
Cause
Action
Содержание cx2100
