NTI TRINITY Ts80, Инструкция по установке и эксплуатации

Страница: 3 / 76

Ts Series Installation and Operation Instructions
│ Trinity Ts
3
1.0 INTRODUCTION
General Installation Requirements
The installation of your NTI Trinity Ts80 gas boiler must conform to the requirements of this manual, your local
authority, and the National Fuel Gas Code ANSI Z223.1 and or CAN/CGA B149 Installation Codes. Where
required by the Authority, the installation must conform to the standard for “Controls and Safety Devices for
Automatically Fired Boilers ANSI/ASME CSD-1.
This document pertains to the correct installation and operation of NTI Trinity boiler model Ts80. The
instructions detailed in this document supersede any and all previous instructions provided by NTI, written or
otherwise. Each unit is provided with the following:
1.
Installation and Operating Instructions,
2. Trinity Users Manual, and
3. Natural Gas to LP Conversion Kit.*
* The conversion kit is required to convert the boiler so it will safely operate with Propane Gas.
Read and understand this entire document prior to proceeding with the installation of the
Trinity Ts. Failure to follow the instructions outlined in this document will result in
property damage, serious injury or death.
User Responsibilities
This boiler must be installed and serviced by a qualified installer or service technician. This boiler must be
serviced and inspected annually when operating in normal residential applications. Demanding applications or
extreme conditions (i.e. commercial) may require more frequent service and inspection. As the User/Owner of
this equipment, you are responsible for ensuring the maintenance is performed at the required intervals.
Failure to have the boiler properly serviced and inspected on a regular basis by a qualified
service technician may result in property damage, serious injury or death.
Failure to keep the Vent and Combustion Air Intake clear of ice, snow, and other debris
may result in property damage, serious injury, or death.
Installer Responsibilities
As the installing technician it is your responsibility to ensure the installation is performed in accordance with this
instruction manual as well as any applicable local or National installation codes. It is also your responsibility to
inform the User/Owner of their obligation with respect to the above description under “User Responsibilities”.
Failure to follow this warning could result in fire, serious injury, or death.
Failure to use the appropriate Natural to LP Conversion Kit and Orifice when operating
the Trinity Ts with Propane will result in extremely dangerous burner operation leading
to property damage, serious injury or death. Refer to section titled
ATTENTION: LIQUEFIED
PETROLEUM (LP) PROPANE
for applicable conversion kit and LP orifice numbers.
ATTENTION: LIQUEFIED PETROLEUM (LP) PROPANE
The Trinity Ts is factory set to operate with Natural Gas. BEFORE OPERATING WITH PROPANE, the
specified LP Conversion Kit and Orifice must be installed to convert the boiler so it will operate safely with
LP Propane. The correct kit and LP orifice is listed below.
Liquefied Petroleum (LP) propane gas is heavier than air; therefore, it is imperative that your Trinity Ts boiler
is not installed in a pit or similar location that will permit heavier than air gas to collect. Local Codes may
require boilers fueled with LP gas be provided with an approved means of removing unburned gases from the
room. Check your local codes for this requirement.
Natural to LP Propane Conversion Kit
_
Model Number Kit Number LP Orifice
Trinity Ts80 82650-1 34 (3.4mm)