New Holland T6010 DELTA, Руководство оператора

Страница: 72 / 412

SECTION 2 -- CONTROLS, INSTRUMENTS AND OPERATION
2--44
Error Codes
The advanced electronics on your tractor are able to
detect a malfunction or error occuring in key areas
such as engine, transmission, electrical and
hydraulic systems. Should a malfunction or error
occur, a symbol will appear in the DMD with a four
digit error code. This may be accompanied by the
illumination of a warning light and an audible alarm
depending on the severity of the fault. Consult your
authorised dealer.
Active and Non Active Warnings
84
In addition to the error codes previously described,
there are a number warning symbols that may
appear in the Dot Matrix Display. These symbols will
be accompanied by either a Red (critical) or Amber
(non--critical) warning light.
Critical symbols appearing with a Red warning light
will remain permanently displayed until the tractor is
stopped and the fault rectified.
Non critical symbols accompanied by the Amber light
will be displayed for five seconds before the DMD
defaults to the symbol previously shown. The amber
warning light will continue to illuminate.
By using the CAL/SEL button, or the Enhanced
Keypad where fitted, active warnings that are not
permanently displayed may be recalled.
Using the CAL/SEL button
•
Depress and hold the CAL/SEL button for three
seconds to enter SETUP MENU , after two
seconds the display will change to CAL. Using
the clock set buttons H and M to toggle the
display, select the the active warning symbol (1),
Figure 85.
•
Depress the CAL/SEL button and the active
symbol will be replaced with a symbol
corresponding to the fault detected.
•
If more than one warning symbol has been
stored, the display will cycle through each one in
turn. After the fault symbols have been
displayed, the screen will default back to the
active warning symbol.
•
Momentarily depress the dimming button to exit
the display.
85