New Holland T6010 DELTA, Руководство оператора

Страница: 258 / 412

SECTION 3 -- FIELD OPERATION
3--124
With Non Adjustable Front Wheels
Tractors equipped with non adjustable front wheels
offer a choice of two track settings. To alter the track
width, interchange both front wheels to provide a
narrow ( A ) or wide ( B ) track setting as required.
NOTE: Tractors with a 50 K/mh (31 MPH)
transmission will be fitted with non adjustable front
wheels).
NOTE: When interchanging left and right--hand
wheel assemblies, ensure the “V” of the tread at the
top of the tyre remains pointing in the direction of
forward travel.
A
B
215
Track settings with 24” and 28” Wheels
4WD Front axle type Position Track Setting
Standard -- min. setting A 1854 mm (73.0 in.)
Standard -- max. setting B 2080 mm (81.9 in)
Suspended -- min. setting A 1821 mm (71.7 in.)
Suspended -- max. setting B 1978 mm (77.9 in.)
Supersteer -- min. setting A 1821 mm (71.7 in.)
Supersteer -- max. setting B 1978 mm (77.9 in.)
NOTE: The track widths in the table above are
nominal and may vary by up to 28 mm (1.1 in.)
dependent upon wheel rim offset.
REFITTING THE FRONT WHEELS
When refitting or adjusting a wheel, tighten the bolts
to the following torques then re-check after 50 hours
of operation and, thereafter as required.
Disc to hub nuts 294 Nm (217 lbf.ft.)
Disc to rim nuts 250 Nm (184 lbf.ft.)
(where applicable)
WARNING
Never operate the tractor with a loose wheel rim or
disc. Always tighten nuts to the specified torque and
at the recommended intervals. Owners should
ensure that all steering components are maintained
in a reliable and satisfactory condition to ensure safe
operation and comply with legal requirements.