SECTION 2 -- CONTROLS, INSTRUMENTS AND OPERATION
2--105
NOTE:
The following applies only to tractors fitted
with a steering angle sensor.
•
Wheel speed falls below 10 Km/h (6.2 MPH) and
steering angle exceeds
30
°
(21
°
with
SuperSteer). Four wheel drive will re--engage
when the steering angle is reduced.
•
Wheel speed is between 10 and 20 Km/h (6.2
and 12.4 MPH) and steering angle exceeds 25
°
(17
°
with SuperSteeer). Four wheel drive will
re--engage when the steering angle is reduced.
NOTE:
The above steering angles are set during
manufacture, if an alternative angle setting is
required, consult your authorised dealer.
The indicator light (1) Figure 156 on the instrument
panel will also illuminate but will only remain lit when
four wheel drive is engaged.
NOTE:
To avoid excessive tyre wear when travelling
on the public highway or any hard surface, it is
recommended that four wheel drive be disengaged.
WARNING
Tractors with four wheel drive engaged or
disengaged should not be allowed to overspeed by
towing or coasting downhill with clutch depressed or
transmission in neutral. This may cause loss of
control, personal injury to the operator or bystanders
or failure of the drive shaft.
NOTE:
Keep the tractor in the same gear going
downhill as would be used when going uphill.
WARNING
Your tractor is equipped with very efficient,
hydraulically actuated rear wheel brakes. On four
wheel drive tractors the drive to the front axle is
automatically engaged, at speeds above 8.5 km/h
(5.2 MPH), when the brakes are applied, to provide
four wheel braking. Owners should be aware of the
effectiveness of four wheel braking which greatly
enhances braking performance. Care should be
taken during heavy braking, particularly if the rear of
the tractor is unballasted.
156
Содержание T6010 DELTA
