SECTION 2 -- CONTROLS, INSTRUMENTS AND OPERATION
2--52
•
As the centre of the front tyres passes over the
finish line, press and release the CAL/SEL button
(1) again,
CAL auto OK
will appear in the Dot
Matrix Display. Depress the CAL/SEL button again
select
CAL
display. Turn off key--start to save the
setting.
94
Manual Calibration with CAL/SEL Button
The manual calibration allows the operator to set the
rolling circumference of the rear tyre (if known)
without the need to drive over a measured distance.
•
With the tractor stationary and the key--start on,
depress and hold the CAL/SEL button for 3
seconds to display
SETUP_MENU
. After 2
seconds this will change to
CAL
. Depress the
CAL/SEL button again to select
CAL
man_000.0.
(The figure
000.0
may differ if a
calibration number has previously been
entered).
CAL
will flash in the speed display.
95
NOTE:
The set up procedure may be cancelled at
any time by depressing the LCD dimmer control
button or by turning the key--start off.
IMPORTANT:
When entering new tyre rolling
circumference
figures,
use
metric
values
(centimetres) with
Km/h
speedometer reading and
Imperial values (inches) with
MPH
reading, see table
on page 2--55.
•
By depressing the ’h’ and ’m’ clock buttons, the
rolling circumference of the rear tyre may be
entered into the numerical display (
000.0
).
•
Depress the ’h’ button to select the first digit to be
changed, repeated operation of the ’h’ button will
cycle the cursor through all the digits in turn. To
alter the value of the digit selected, momentarily
depress the ’m’ button until the correct figure is
shown.
•
With the new rolling circumference figure
entered into the display, depress the CAL/SEL
button again to display
CAL
. Turn the Key--start
off to save the setting.
Содержание T6010 DELTA
