New Holland T6010 DELTA, Руководство оператора

Страница: 312 / 412

SECTION 4 -- LUBRICATION AND MAINTENANCE
4--32
To change the oil and filter:
1. Warm the engine to operating temperature. Stop
the engine, remove the engine oil drain plugs (1)
which are located at the rear of the sump on
either side of the engine. Catch the oil in a
suitable container and dispose properly.
2. Replace the drain plugs after the oil has drained.
62
3. Clean the oil filter area. Unscrew the oil filter (1)
and discard. Catch any residual oil and dispose
of properly.
4. Clean the new filter mounting surface and apply
a thin coat of oil on the new filter sealing ring and
install the filter. Turn until the sealing ring
contacts the mounting surface, then tighten an
additional
3
/
4
to 1 full turn. Do not overtighten..
5. Remove Dipstick/Filler cap, Figure 64, and fill
with the correct amount of fresh oil as indicated
below. Ensure the oil is of the correct grade and
viscosity.
63
6. Start the engine and run for 3 minutes at idle
speed then stop the engine.
7. Check the drain plugs and oil filter areas for
leaks.
8. Wait 5 minutes to allow the oil to drain into the
crankcase, then check the oil level on the
dipstick. The oil level should fall between the
‘MIN’ and ‘MAX’ on the dipstick. Add more oil as
required.
NOTE: Do not fill above the ‘MAX’indicator on the
dipstick. Excess oil will burn off, creating smoke and
give a false impression of oil consumption. Do not
operate the engine with the oil level below the lower
notch.
9. Re--install the dipstick/filler cap.
See page 4--9 for the correct oil specification.
64