New Holland T6010 DELTA, Руководство оператора

Страница: 90 / 412

SECTION 2 -- CONTROLS, INSTRUMENTS AND OPERATION
2--62
Setting the Slip Alarm Point
NOTE: If the optional radar unit is not installed, the
slip alarm function will be omitted from the display.
The slip alarm point may be set as a one or two digit
figure that, if exceeded, will cause an audible alarm
to sound. To set a wheel slip limit of 15% carry out the
following procedure.
•
With the key--start in the ON position, depress
and hold the Menu/Enter key for 3 seconds. The
DMD will read SETUP_MENU, this will change
to CAL after 2 seconds. Using the Menu
Up/Down keys, scroll through the menu until the
wheel slip symbol (1) is displayed.
•
Depress the Menu/Enter key again to select the
set--up screen, a flashing cursor will appear at
the first number to be set. Using the Digit Value
key enter ’1’ , move the cursor to the right with the
Digit Select key and, with the Digit Value key,
enter ’5’. The slip alarm point is now set at 15%.
•
Touch the Menu/Enter key to memorise the
setting and return to the main menu.
If wheel slip exceeds the pre--set limit, the slip symbol
will appear in the DMD and the amber warning light
will illuminate on the instrument console.
110
Audible Beep -- ON/OFF
Each time one of the keys is pressed, an audible
’beep’ sound will be heard. The beep can be switched
off if required.
•
With the key--start in the ON position, depress
and hold the Menu/Enter key for 3 seconds. The
DMD will read SETUP_MENU, this will change
to CAL after 2 seconds. Using the Menu
Up/Down keys, scroll through the menu until
BEEP ON/OFF is displayed.
•
Depress the Menu/Enter key again to select the
set--up screen. Using the Menu Up/Down keys,
align the arrow (1) with ON or OFF as required.
•
Touch the Menu/Enter key to store the setting
and return to the main menu. Depress the
Exit/Cancel key to return to the original display.
111