Nemox Gelato 6 K Crea Series, Инструкция

Страница: 5 / 60

English
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be observed, including the
following:
•Read all instructions carefully.
•To protect against risk of electric shock, do not put the main body of appliance in water or any other liquid.
•This appliance has not been designed to be used by persons (including children) with physical, sensory
or mental impairments or who are lacking in experience or knowledge, unless they have been given the
necessary supervision and prior instructions about how to use this appliance by a person responsible for
their safety. Young children should be supervised to ensure that they do not play with the appliance.
•Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning.
•Avoid contact with moving parts.
•Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions, or is
dropped or damaged in any manner. Return the appliance to an authorised Service Center for
examination, repair or electrical or mechanical adjustment.
•The use of attachments not recommended or sold by the appliance manufacturer may result in fire,
electric shock or injury.
•Do not use outdoors.
•Do not let cord hang over edge of table or counter, or touch hot surfaces.
SAVE THESE INSTRUCTIONS
CAUTION
•
An authorised service representative should perform any servicing other than cleaning and user
maintenance. Authorised service personnel only should do repair.
•
After removing the appliance from the packaging, check it for damage. If in doubt, do not use the
appliance and contact an authorised service centre.
•
Plastic bags, polystyrene, nails, etc. must not be left within reach of children as they are potentially
dangerous.
•
The appliance's manufacturer and vendor reject any responsibility for failure to comply with the
instructions provided in this user manual.
•
Check that the voltage shown on the rating plate corresponds to the voltage of the mains.
•
Do not use sharp utensils inside the bowl! Sharp objects will scratch and damage the inside of the bowl.
A rubber spatula or metal spoon may be used, when the appliance is in the “OFF”or “0” position.
•
Never clean with scouring powders or hard implements.
•
Do not place or use the appliance on or near hot surfaces, such as stoves, hotplates, or near open gas
flames.
•
Do not unplug the unit by pulling on the cord.
•
The appliance must be connected to an electrical system and power supply socket with a minimum
capacity of 16A, equiped with an efficient earth contact. The manufacturer is not responsible for
damages to things or people in the event that the prescribed safety norms have not been respected.
•
Before carrying out any maintenance or cleaning operations, make sure that the appliance has been
disconnected from the electrical mains by removing the plug from the power supply socket.
•
Never wash the appliance using water jets or place it in water!
•This appliance is suitable for use with 43°C max. ambient temperature (climatic class “T”).
IMPORTANT:
This Ice Cream Machine contains its own refrigerant which must be allowed to settle after transport. Leave
the Ice Cream Machine on a horizontal surface for at least 12 hours after purchase or after any move which
might have stored the machine the wrong way up.
Leave at least 20 cm on each side of the machine to allow free air circulation. Make sure the vent slots are
free and unobstructed.
English
UK USERS ONLY
HOW TO CONNECT THE CORD TO A U.K. PLUG: IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
•Green and yellow:
Earth
•Blue: Neutral
•Brown: Live
Please, read the instructions given below before connecting the cord to a plug.
If in doubt, please, consult a qualified electrician. As the colours of the wires in
the mains lead of this appliance may not correspond with the coloured
markings identifyng the terminals in your plug, proceed as follows: the wire
that is coloured Green and Yellow must be connected to the terminal in the
plug which is marked with the letter E or the Earth symbol (
G ), or coloured
Green or Green and Yellow.
The wire that is coloured Brown must be connected to the terminal which is
marked with the letter L or coloured Red. The wire that is coloured Blue must be
connected to the terminal which is marked with the letter N or coloured Black.
SAFETY POINTS FOR REWIRABLE OR MOULDED PLUG
The mains lead of this appliance may be already fitted with a BS1363 13A plug.
•If your socket outlet is not suitable for the plug, then the plug must be removed (cut off if it is a moulded on plug),
the flexible cord insulation should be stripped back as appropriate and a suitable 3 pin plug fitted.
•WARNING: Dispose of a plug that has been cut from the power supply cord, as such a plug is hazardous if
inserted in a live 13A socket outlet elsewhere in the house.
•Should the fuse need to be replaced an ASTA marked fuse, approved to BS 1362, of the same rating must be
used.
•Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted or lost until a
replacement is obtained. Make certain that only the correct fuse cover is used and fitted.
•For plugs with detachable fuse cover, the replacement must be the same as the colour insert in the base of the
plug, or as directed by the embossed wording on the base of the plug.
•If the detachable fuse cover is lost a replacement may be purchased from a Service Centre.
•Information for supply may also be obtained from the plug manufacturer.
4 5
1). Cooling button.
1a). Cooling system
operation LED.
2). Mixing paddle button.
2a). Paddle operation LED.
3). Transparent lid.
3a). Hole to add ingredients
with cap.
4). Paddle locking ring.
5). Mixing paddle.
6). Ventilation grid.
7). Water discharge cap.
8).
Paddle speed adjustment
knob.
9). Water discharge cap.
10). Master light switch.
11). Program selection button.
11a). Gelato italiano ice
cream program LED.
11b). Semi soft Gelato
program LED.
11c). Granita program LED.
11d).
Fast cooling
program LED.
12). Preservation time
selection button.
12a). Preservation cycle
No.1 LED.
12b). Preservation cycle
No.2 LED.
12c). Preservation cycle
No.3 LED.
12d). Preservation cycle
No.4 LED.
13). Oil seal.
14). Spatula.
15). Paddle plastic sleeve gasket set.
16). Water discharge tap gasket set.
17). Paddle plastic sleeve.
18). Vertical scraper.
19). Horizontal scraper.
20). Interlocking buffer.
21). Cleaner.
Congratulations!
You have purchased a latest generation
NEMOX ice cream machine.
In addition to producing all the ice cream,
sorbet and Granita you want, you can also
conserve the preparations in the pot, so they are
always at the ideal serving temperature and
density.
An onboard computer will help you get the job
done in the best way, enhancing your
professionalism and hard work and saving you
valuable time. Your ice cream machine has two types of
operation:
•
, t h e o p e r a t i o n o f t h e M a n u a l m o d e
compressor and paddle are independent so
as to make the most of your experience. The
preservation system can be started on its own
if you consider it appropriate. An electronic
device stops the paddle when the consistency
of the preparation is excessive, thus
preventing compromising the mechanical
functions of the machine. The cooling system
will continue to run until it is manually stopped.