MUTOH Kona 1400, Руководство пользователя

Страница: 84 / 218

User’s Guide Kona / Kona apparel cutting plotter
Operation panel
84 AP-75370 - Revision 1.1
Step 2:
Select the tool

Drag knife

Pen
Step 3:
Confirm with
Step 4:
Perform the EPOS alignment check to be sure the distance between EPOS sensor
and knife/pen point is set correctly. Otherwise, it might occur that the data is cut with
an offset.
Refer to
Epos on page 98
Velocity
Set the tool down speed of the active tool.
The speed can be set as well on the cutter panel as in the cut software. When the speed is
set in the software, the panel speed is overruled when the function VS/ZF/AS is enabled (by
default).
Refer to
Protocol on page 115
In this case, the tool down speed is the speed of measuring up the box in X-direction. The tool
speed in Y-direction will always be the maximum tool up speed (100 cm/s). It is possible to
gain some time when you set the real cutting speed in the software and the bounding box
measuring speed on the control panel.
X-direction
(tool down speed)
Y-direction
(maximum tool up speed - 100 cm/s)