MUTOH Kona 1400, Руководство пользователя

Страница: 109 / 218

User’s Guide Kona / Kona apparel cutting plotter
Operation panel
AP-75370 - Revision 1.1 109
4
Follow the procedure below to make the appropriate settings:
Step 1:
Press the following buttons in order:

Settings

Cut through

Click
tool

Select the tool you want to use and confirm with

Set the values for the
velocity
and
force
.
Step 2:
Enter the desired values and confirm with
Step 3:
Press the
test
key to verify the quality of the through cutting settings.
Step 4:
Set the values for the
tool up
and
tool down
distance.

Go to the next sub page

Select Up Dist. and/or Down. Dist.
Step 5:
Enter the desired values and confirm with
Step 6:
Press the
test
key to verify the quality of the through cutting settings.
Step 7:
Check if it is easy to push out the cut patterns. If not, try to increase the force and
knife depth or to decrease the tool down distance.
Refer to
Force on page 85
and
Adjusting the knife depth on page 48
Step 8:
Be sure to perform a sheet-off after the test because the pushed-out squares/circles
will uncover the paper sensor which could lead to an error.