Motorola WiNG 5.6, Справочное руководство

Страница: 262 / 1048

5 - 176 WiNG 5.6 Access Point System Reference Guide
This screen provides configuration for the 2.4 GHz and 5.0/4.9 GHz frequencies. Refer to the following for more information
on the
Auto Channel Selection Dynamic Root Selection screen. These descriptions are common for configuring the 2.4 GHZ
and 5.0/4.9 GHz frequencies.
10. Click the Path Method SNR tab to configure the signal to noise ratio values when selecting the path to the mesh point
root.
Channel Width Configure the channel width that mesh point automatic channel scan should assign to the
selected radio. The available options are:
• Automatic – Indicates the channel width is calculated automatically. This is the
default value.
• 20 MHz – Indicates the width between two adjacent channels is 20 MHz.
• 40 MHz – Indicates the width between two adjacent channels is 40 MHz.
Priority Meshpoint Configure the mesh point monitored for automatic channel scan. This is the mesh point
given priority over other available mesh points. When configured, a mesh is created with
this mesh point. When not configured, a mesh point is automatically selected.
Off-channel Duration Configure the duration in the range of 20 - 250 milliseconds for the Off Channel Duration
field. This is the duration the scan dwells on each channel when performing an off
channel scan.
Off-channel Scan
Frequency Configure the time duration in seconds between two consecutive Off Channel Scans. Set
a duration between 1 - 60 seconds.
Meshpoint Root - Sample
Count Configure the number of scans to be performed for data collection before a mesh channel
is selected. Set a value between 1 - 10 scans.
Meshpoint Root - Channel
Hold Time Configure the minimum duration to stay on a selected channel before the channel
conditions are reassessed for a possible channel change. Set a value between 0 - 1440
minutes. Set this value to ‘Zero’ (0) to prevent a automatic channel selection from
happening.