Motorola WiNG 5.6, Справочное руководство

Страница: 457 / 1048

Device Configuration 5 - 371
13. Refer to the following AP Load Balancing fields to configure or override them:
14. Refer to the following Band Control parameters to configure or override them:
15. Refer to the following Neighbor Selection parameters to configure or override them:
Min Value to Trigger
Load Balancing Use the spinner control to set the access point radio threshold value (from 0 - 100%) used
to initiate load balancing across other access point radios. When this radio load exceeds
the defined threshold, load balancing is initiated. The default is 70%.
Max. AP Load
Difference Considered
Equal Use the spinner control to set a value (between 0 - 100) considered an adequate discrepancy
when comparing access point radio load balances. The default setting is 1%. Thus, using a
default setting of 1% means 1% is considered inconsequential when comparing access
point radio load balances.
Weightage given to
Client Count Use the spinner control to assign a weight (between 0 - 100) the access point uses to
prioritize 2.4 and 5 GHz radio client count in the overall 2.4 and 5GHZ radio load calculation.
Assign this value higher if this access point is intended to support numerous clients and
their throughput is interpreted as secondary to maintaining client association. The default
setting is 90%.
Weightage given to
Throughput Use the spinner control to assign a weight (between 0 - 100) the access point uses to
prioritize throughput in the access point load calculation. Assign this value higher if
throughput and radio performance are considered mission critical within the access point
managed network. The default setting is 10%.
Max. Band Load
Difference Considered
Equal Use the spinner control to set a value (between 0 - 100) considered an adequate discrepancy
when comparing 2.4 and 5GHz radio band load balances on this access point. The default
setting is 10%. Thus, using a default setting of 1% means 1% is considered inconsequential
when comparing 2.4 and 5 GHz load balances on this access point.
Band Ratio (2.4GHz) Use the spinner control to set a loading ratio (between 0 - 10) the access point 2.4 GHz radio
uses in respect to radio traffic load on the 2.4 GHz band. This allows an administrator to
weight client traffic load if wishing to prioritize client traffic load on the 2.4 GHz radio band.
The higher the value set, the greater the weight assigned to radio traffic load on the 2.4 GHz
radio band. The default setting is 1.
Band Ratio (5 GHz) Use the spinner control to set a loading ratio (between 0 - 10) the access point 5 GHz radio
uses in respect to radio traffic load on the 5 GHz band. This allows an administrator to
weight client traffic load if wishing to prioritize client traffic load on the 5 GHz radio band.
The higher the value set, the greater the weight assigned to radio traffic load on the 5 GHz
radio band. The default setting is 1.
5 GHz load which both
bands enable Use the spinner control to set a load percentage (between 0 - 100) that enables the other
band (2.4 GHz) to share load with the current band.
2.4 GHz load which
both bands enable Use the spinner control to set a load percentage (between 0 - 100) that enables the other
band (5 GHz) to share load with the current band.
Minimum signal
strength for common
clients Use the spinner to set the minimum signal strength require to learn about neighbors from
clients that are common with the neighbor access point.
Minimum number of
clients seen Use the spinner to set the minimum number of common clients seen before the neighbor is
learnt.