A. A
RMREST
H
EIGHT
A
DJUSTMENTS
:
Our tilt-only style Cantilever Armrests are secured to their respective tilt back canes and connected together
by a stabilizing spreader bar assembly. The tilt-only cantilever armrests offer a variety of adjustment options
to alter the armrest angle, width and height. There are two styles of cantilever armrests tubes available: Straight
or 4” Drop; and two different lengths: desk length and full length. Each cantilever armrests can also be manually
lifted/ flipped backward to allow for side transfers into and out of the wheelchair, when required.
(Note: Arm pads not shown
)
Straight
Armrest
4” Drop
Armrest
Armrest can be flipped
back to provide clearance
and allow for side transfers
spreader bar
tilt back cane
tilt back cane
SIDE VIEW
cane clamp
adjustment
screws
for combined arm height adjustments, loosen the left
and right cane clamp assemblies, then slide both
armrests (simultaneously) up/down the back canes
cane clamp
assembly
2
1
i) Synchronized Cantilever Arm Height Adjustments (on Tilt Back Canes)
1. To adjust, loosen the left & right cane clamp assemblies
(3 screws per clamp)
(
1
), then slide the entire
cantilever armrest assembly up or down along the tilt back canes (
2
) to the desired arm height.
2. Following adjustment, fully re-tighten the mounting hardware on both cane clamps assemblies.
5.3.4 CANE MOUNTED TILT-ONLY CANTILEVER ARMRESTS
WARNING! Risk of serious injury or damage.
•
When performing transfer activities into and out of the wheelchair, DO NOT use the armrest for load
bearing support. To prevent the risk of personal injury and/or damage to the armrests, transfers should be
performed using designated transfer handles, and in the presence of an attendant whenever possible.
5.0
5.0
SEATING ACCESSORIES & COMFORT ADJUSTMENTS
SEATING ACCESSORIES & COMFORT ADJUSTMENTS
- 54 -
Содержание ULTRA-LOW MAXX UPFRONT MPPS
Страница 99: ......