The push rod assembly can be adjusted
inward
or
outward,
as necessary, to set the initial angle of the
armrest tube in the upright seat position.
(Typical set-up is 0° or horizontal as illustrated)
- see
Figure
1.0,
Step .
(
Note:
Push rod adjustments may also be required as part of the armrest height adjustment
in step
1.
above).
To Adjust Push Rod:
1. Loosen the
jam nut
on the push rod;
2. Rotate the threaded
adjustment nut
to extend/retract the push rod assembly to the desired length.
3. Tighten jam nut.
The following section illustrates the basic cantilever armrest adjustments available. (
Please Note:
Armrest
adjustments should be made with the seat placed in the full upright position):
R
ECLINE
M
AXX
C
ANTILEVER
A
RMREST
A
DJUSTMENT
/ S
ET
-U
P
:
5.3.5 CANE MOUNTED RECLINE CANTILEVER ARMRESTS:
Adjust the armrest receiver mounts (left & right) independently to the desired height along the recline back
canes. The receiver mounts control the overall height of each cantilever armrest, and may be set to different
heights if preferred- see
Figure 1.0,
Step .
(
Note:
In order to achieve the desired height/armrest angle,
it may be necessary to also adjust the push rod assembly- see step
2
. below)
To Adjust Armrest Height:
1. Loosen the
t-nut
hardware securing the receiver mount to the recline back cane (
loosen only-do not remove
);
2. Slide the armrest & receiver mount assembly upward/downward along the recline cane to the desired height.
3. Tighten the
t-nut
hardware to secure in place.
(Adjust push rod if necessary to achieve desired armrest angle).
(left armrest ass’y shown)
The armrest tubes (arm pads) may be adjusted to one of three optional widths relative to the seat and
back width.
(Default armrest width is fully inward (
0”
)).
Each armrest can be adjusted independently
up to 2” wider than the seat width if necessary - see
Figure 2.0,
Step
To Adjust Armrest Width:
1. Loosen/remove the
adjustment screw
on the inside of the receiver mount;
2. Slide the armrest tubeinward/outward to the desired width;.
3. Re-install the adjustment screw.
1
1.
2.
3.
2
3
Armest may be lifted upward
to provide clearance and
allow for side transfers
WARNING! Risk of serious injury or damage.
•
When performing transfer activities into and out of the wheelchair, DO NOT use the armrest for load
bearing support. To prevent the risk of personal injury and/or damage to the armrests, transfers should
be performed using designated transfer handles, and in the presence of an attendant whenever possible.
The cane mounted Recline Cantilever Armrests are secured independently to their respective recline back cane
and offer a variety of adjustment options to alter the angle, width and height as necessary. The recline cantilever
armrest is also designed to flip back to allow for side transfers when required.
5.0
5.0
SEATING ACCESSORIES & COMFORT ADJUSTMENTS
SEATING ACCESSORIES & COMFORT ADJUSTMENTS
- 58 -
Содержание ULTRA-LOW MAXX UPFRONT MPPS
Страница 99: ......
